crankshaft
The AC Belt connects to the crankshaft pully outer pully the one in front of the crankshaft belt
to the air box
For most engines there is no need to change the crankshaft to use an engine for an automatic or a manual transmission. For an automatic, connect a flex-plate to the crankshaft. For a manual transmission connect a flywheel.
Connect timing light to battery and No. 1 cylinder and aim light at crankshaft Connect timing light to battery and No. 1 cylinder and aim light at crankshaft timing marks
One end of it has a piston on it and the other end bolts to the crankshaft.
In a reciprocating engine, the connecting rod is used to connect the piston to the crankshaft. It converts the linear motion (reciprocating motion) of the piston to the circular motion of the crankshaft.
A portable crank that used to connect to the crankshaft in the front of the car.
Somewhere by the crankshaft Facing the 3.5 engine from front of car, left rear. Sensor is connect to housing seem on transmission where connect to motor. It has a three prong clip and a 10 mm bolt securing sensor to housing. Best access is from bottom of engine. If you have a lift, it takes about 10 minutes to replace. Good Luck.
Both..a chain to connect the crankshaft with the injection-pump..and a toothed belt connects the pump with the camshaft. gr.
Where does a crankshaft sit
Crankshaft position and crankshaft RPM