It means you turned it off, usually a little button on the end of the shifter.
is this a manual box with the button on the top of the stick to get 5 st overdrive gear drive in forth up to 40 mph then press the button overdrive light green light now on press to come out of overdrive or change down a gear to third.
because flashing green lights mean go and the green lights that are not flashing mean stop
when you push the overdrive button the green light is letting you know that the overdrive is "off". Therefore you are driving in a lower gear. This is a good thing if you are towing a trailer or maybe going up a hill or bridge. It keeps you from burning up your transmission, but otherwise if your just driving normal then overdrive needs to be "on" which is more fuel efficient by allowing you to switch into a higher gear.
It is the button on the Dash board just below the green flashing light of the right turn indicator Operates when ignition is on. After the trip mileage record is displayed a long press of this button resets it to zero.
You hold the power button down until the green light next to it stops flashing.
A flashing amber light means approach the lock at a safe speed and under full control.
It is the button on the Dash board just below the green flashing light of the right turn indicator Operates when ignition is on. After the trip mileage record is displayed a long press of this button resets it to zero.
The overdrive has been switched off , the switch is on your gear selector ( the smaller button that is lower down )
If they have a green flashing light on top of their car, then they are a Doctor, and have as much priority as a regular emergency vehicle.
it is quite simple...throw snowballs in the barrel and when the button turns green push it...but if the dragons eyes start flashing throw snowballs at him...he is actually mechanical
Step 1: Turn on your device. Press the GREEN SET button. While holding the GREEN SET button, press the device button you want to program. Release both buttons. Step 2: Press the GREEN SET button again. The red light should start flashing. Step 3: Start pressing the power button until your device turns off. Step 4: Press the device button again. Step 5: Enjoy!
Cleared to cross