0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Can you put a 25 amp fuse in a 50 amp maxi fuse holder?
Install the fuse that is required for the circuit.
Can a 10 amp AGC fuse be used in a 10 amp rated DC circuit?
Yes, as long as the fuse is able to be inserted into the fuse holder it will work.
Your lighter 15 amp fuse will not stick into the circuit board fuse box?
The receiving end must be damaged. Gain access to the back side of the fuse box, locate the wires connected to that circuit, cut and splice in a 20 amp in-line fuse holder, install a new 15 amp fuse into the new fuse holder and replace fuse box with the new fuse exposed to one side to gain access for future needs.
Why do you get 24 volts on my HVAC air handler when the fuse is out and 7 volts when the fuse is put back in?
You are reading the voltage across the fuse holder and getting a back reading from another piece of control equipment that is using a common return. The reading should be taken from a common ground or neutral point to one side of the fuse holder. You should be looking for the circuit voltage value and then from the other side of the fuse holder to ascertain that the fuse has not blown.
Why would a 63 amp fuse holder get hot?
The only time that fuse holders gets hot is when there is a loose connection between the fuse holder and the wire connected to the holder. If this is happening remove the supply voltage from the circuit that the fuse holder is in. Remove the wire from the holder. Cut the burned end of if there is enough wire and re install. If not enough wire, use a wire brush to get the oxidation off of the wire. Apply a coating of anti oxidation compound on the wire end and then re install into the holder. Tighten the wire into the holder very tightly. Check the spring clamping pressure of the fuse end of where the heating occurred. This spring clamping pressure is important for low resistance conductivity. If the fuse feels loose when installed change the fuse holder for a new one.
How do you reset the circuit breaker on the cigarette lighter on a 63 ford falcon?
It does not have a circuit breaker. It uses a fuse to protect the circuit. Look for a blown fuse in the fuse panel under the dash on the drivers side.I believe the cigarette lighter circuit is protected with a glass barrel fuse not a circuit breaker. Check the fuse box for a blown fuse.
Is fuse a part of a circuit?
When there is a fuse, yes it is part of a circuit. The fuse is a cheap, replaceable circuit breaker to avoid damage to the circuit components.
Is a fuse a circuit?
a fuse is a way to secure a circuit from owerload, so a fuse is in a way a circuit in a circuit that owerload itself and breake the circuit inside itself to not damege the rest of the circuit. OR some thing conected to that sircuit.
How do you change wire fuse for circuit breaker?
A circuit breaker does not have a wire fuse in it.
What is the best suitable component for circuit protection instead of fuse?
circuit breaker, or "resettable fuse", which is a reallya small circuit breaker in the housing of a fuse
What is the function of the fuse or circuit breaker in a circuit?
A circuit breaker/fuse is designed to protect the wiring from getting overloaded.
What device protects an electrical circuit?
An example of a circuit protection device is a fuse. Another example is a circuit breaker.
