0
What does a layer 2 switch use to decide where to forward a received frame?
CarlintonBoswell
A layer 2 switch uses the MAC address to determine which port to switch the frame out of.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
When would a LAN switch use flooding to forward a frame?
mashallah
What is accurate about fast-forward switching?
The switch stores the first 64 bytes of the frame before forwarding.
What does a switch store in its switching table?
The destination mac addressof a frame and the port it was received on.
A switch received a frame with a destination mac address that is currently not in the mac table what action does the switch performs?
It will broadcast to every port in the vlan.
In what mode does a switch read the entire data frame into its memory and checks it for accuracy before transmitting the information?
Store and forward mode
What switch them based on in this mode reads the entire data frame into its memory and checks it for accuracy before transmitting the information?
Store-and-forward mode.
Which switch forwarding method should be used on network that employs frame classification based on an assigned quality of service value?
store-and-forward
What is A switching mode in which a switch reads a frame's header and decides where to forward the data before it receives the entire packet?
Cut-through mode.
What does the term dynamic indicate in the output that is?
The switch learned this MAC address from the source address in a frame received on Fa0/18.
What processes does a switch follow before it forwards a frame in store and forward mode?
it receives the complete frame it reads the source and destination addresses it preforms a cyclic redundancy check it applies the relevant filters.
Why does a switch flood a frame?
Because it is a broadcast frame Because it is a multicast Frame Because the switch has no MAC address for it.
What are the release dates for Frame Switch - 2014?
Frame Switch - 2014 was released on: USA: 2014
