An anti-static mat is usually made of a conductive plastic. Usually, on one corner there is a snap connector. From that snap connector there is a long, (usually GREEN) wire, as well as a coiled wire that goes to a wrist strap. The green wire goes to the round GROUND connector of an AC wall socket. The coiled wire that goes to a wrist strap goes just like that. Wrap the wrist strap around your wrist. The reason for this setup is, through the green wire to the ground connector, you put both the mat and your body at ground potential. It takes the static electricity from your body,via the wrist strap, and from the mat to ground. Be VERY CAREFULL!! YOU MUST KNOW WHERE THE GROUND IS ON AN AC OUTLET TO USE THIS AS I HAVE OUTLINED. If you do not know where the ground pin is on an AC outlet, you should not use it.
Yes. You should wear one whenever you work inside a computer.
The problem here is that you may encounter high voltages in the power supply. So wearing an antistatic wrist strap may put you at a greater risk of electric shock. Besides, there are few if any sensitive electronic components inside the power supply unit.In addition, make sure the power supply is not connected to any power before servicing it. If you need to go near any large capacitors, you will want to discharge them. In fact that is a good precaution to take any time you remove the circuit board from the power supply unit.
You can use a piece of ordinary wire or just leave one hand always touching the metalic ground of the device you're about to insert or remove circuits into or from.
Yes, wrist is a concrete noun, a word for a physical thing.
Length of wrist strap/Band circumference = 7 inches.
resistors
You can attach the loop of the strap in the bottom left corner of the phone. (you need to open up the back cover first). Enjoy
All wii remotes come with the wrist strap.
The strap of his wrist watch became loose.
You take the wrist strap and look at both ends. One end should have a tinier strap attached to it. You take the tiny strap and look at the back end of the ds. It should have two small holes there. Then take the strap and stick it in one hole. then , push the strap, and it should come out the other hole. Take the strap that came out the hole, and make a loop, by splitting them apart. Slip the actual wrist strap through the loop, and pull it through. Bingo!
the wrist strap will prevent computer components from being damaged by static electricity.
The wrist strap in the PSP Accessory Pak by Mad Catz is able to be adjusted a little bit.
a watch worn on a strap around the wrist.
not sure
To prevent electrostatic discharge to crucial components regarding the electrical circuit you are performing work on.
To the computer metal case, or you can buy a wireless anti-static wrist band.