Electricity.
Also called ballast resistor. a device, often a resistor, that maintains the current in a circuit at a constant value by varying its resistance in order to counteract changes in voltage.
a device that maintains the current through a fluorescent or Mercury lamp at the desired constant value, sometimes also providing the necessary starting voltage and current.
"Ballast heaver" typically refers to a person or device that assists in stabilizing a ship by adjusting the distribution of weight across the vessel. This is done by moving ballast (heavy material) to counterbalance the ship's load and maintain its stability.
It does not have a ballast resistor.It does not have a ballast resistor.
It does not have an ignition ballast resistor.It does not have an ignition ballast resistor.
If you mean the ballast in a fluorescent light fitting where the ballast is wired in series with the tube, the answer is "No". Explanation: If no tube is in place, the light fitting's circuit is "open" so there is nothing to take any current from the "hot" supply wire and return it to the "neutral" wire.
A ballast that smells burnt is going bad. The ballast will have to be replaced to fix the problem.
A stinger is linemen terminology. Do you mean transformer instead of ballast. Please be more explicit as to what you are doing.
A good sentence for the word ballast is.......The ballast is not heavy enough and the boat is about to sink.
Static weight with opperator -Rear 5430 lb with ballast 2950 lbs without ballast --------------------------------------Front 1810 lb with ballast 1540 lbs without ballast --------------------------------------Total 7240 lb with ballast 4470 lbs without ballast ----
On occasion, ballast is required to bring the centre of gravity within operational limits. There are two methods of carrying ballast: - Ballast (hold loaded) -Ballast fuel: the fuel used for this purpose is called ballast fuel. Trapped Fuel:The fuel in an engine or fuel system that is not in the fuel tanks
To connect a ballast, first, ensure the power is turned off. Then, match the wiring from the ballast to the wiring in the fixture according to the wiring diagram provided with the ballast. Make sure all connections are secure and insulated properly before restoring power.
A ballast is a ballast in most cases. So yes you should be fine.
Ballast Nedam's population is 2,009.