"Double-pole" refers to the type of switch used to disconnect the cooker from the incoming household electricity supply.
Only by using a double-pole switch can the cooker's connections to both the live (or "hot") and neutral supply wires be switched on and off simultaneously.
Double pole and single pole.
iron clad double pole switch
Double pole switches isolate the power by cutting off both phase and neutral simultaneously.
can a 20 amp double pole circuit breaker be used for 2 different 120 v circuits using 14 - 2 wire
because its possible only where pole changing arrangements are given and pole changed motor draws more current then its actual pole which damages its windings.
Double pole and single pole.
The term "double pole" usually means a breaker with 2 handles that attaches in the space as a normal single pole breaker. If this is what you mean, no, you cannot. There is no potential, or voltage, between the wire terminals. If by "double pole" you mean what is usually called a 2-pole breaker, which is a breaker with 2 handles that attaches in the space of 2 single pole breakers, then yes, you can use this breaker and 12/2 wire to produce a 220v circuit.
Double Pole Double Throw
Single pole.
i have required lightings amps rating, how many circuit ku how much amps mcb fixing?
iron clad double pole switch
Yes. The double pole breaker can be removed and replaced with two single pole breakers. The double pole breakers are only used for 240 volt supply loads.
Use of a double pole breaker or a single pole breaker depends entirely on the application. If you don't know about the application, contact a qualified electrician in your area.
Double pole wiring is checked the same way as single pole wiring. When you turn the switch on and the device works, in effect the switch is checked.
For a single throw, double pole switch, each section is wired to the individual items to be controlled. For a double throw double pole (220) set up, both hot wires are run through the switch.
What are Air Force types of ied switches
U.S. 240 VAC breakers are always double pole since they are protecting two legs of the circuit.