Have vehicle scanned to determine the problem - usually in the emission control system
That's your LOW tire pressure warning light in a 2002 Ford Windstar
Scan tool, will give you a trouble code as to why the computer turned the check engine light on.
The 2002 Ford Windstar ECU can be found on the firewall in the engine compartment. The ECU will be on the drivers side of the firewall.
Yes , the only engine that is shown in the 2002 Ford Windstar Owner Guide is the 3.8 OHV , V6 engine * Over Head Valve / pushrod design engine
Good Chance this is caused by a faulty O2 Sensor. I had the engine light stuck on in my 2002 Montana and replaced rear O2 sensor and it turned it off.
You use a scan tool after repairing the cause of the code that turned the light on.
According to the 2002 Ford Windstar Owner Guide : With engine oil filter change ( 5.0 quarts )
According to the 2002 Ford Windstar Owner Guide : With engine oil filter change : The 3.8 liter V6 engine takes : ( 5.0 U.S. quarts of 5W-20 )
On a 2002 Ford Windstar , 3.8 liter V6 engine : The Mass Air Flow sensor is between the cone shaped engine air filter and the engine air intake tube . It is INSIDE a round shaped plastic housing
to be honest idont know
According to the 2002 Ford Windstar Owner Guide : With engine oil filter change : The 3.8 liter V6 engine takes : ( 4.7 liters / 5.0 U.S. quarts of 5W-20 )
On your 2002 Ford Windstar ( 3.8 L V6 ) The engine cylinders are numbered : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver