It means you need to take it in and get serviced. Does it to me when its about time for an oil change.
On my vehicle (Saturn) it indicates that maintenance is required (if the light stays on).
Easy. With key in ignition and car off, press the odometer reset button into full down position. Turn key to position just before full start and continue holding the button until the light goes off and internal maintenance mileage counter light resets. Note the light begins to blink on start up as the maintenance counter nears the schedule before it stays "on" continuously awaiting a reset. This procedure is detailed in the tc manual.
This is a reminder light to tell you to remove the pellets from the catalytic converter, clean them, and put them back in. Yes, there is a reset button. You can safely ignore this light.
If you are referring to the blue temp light on the dash, it stays on until the engine has reached operating temperature. This lets you know the heat will be ineffective and the engine will not be running at peak efficiency during this time.
The light is on because the alternator is not putting out the required voltage. Either the belt is broken, loose, or the alternator is defective.
dome light stays on ford taurus
The airbag light stays on when the computer has detected a malfunction and set a code. A scan tool is required to read the codes. The light can not be reset until the failure is repaired.
No, not as long as the light stays in vacuum.No, it does not. That is where it has its maximum speed.
i have a 97 Nissan altijma and the oil light stays on but i checked the oil level and it is normal but the light flashes when i drive and at an idle it stays on is that oil pump.?
The INFL REST light stays on in your 91 rs camaroRead more:The_INFL_REST_light_stays_on_in_your_91_rs_camaro
The difference between maintenance and troubleshooting is that maintenance means to look after something so that it stays in good condition while troubleshooting is trying to figure out why something is not working as it should.
When the LED light on an aftermarket alarm stays on, it means that the alarm is active. The light generally shows that the alarm status is "ready."