0
What does it mean when the sensor light comes on in a 1987 Mercedes Benz 190E?
Wiki User
∙ 15y ago
If you are talking about the brake sensors then it is time to replace the front brake pads. You should also check the rears while you are at it. When replacing the front brake pads you will also need to change the sensors also.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where are the fuses for the dashboard light on a Mercedes 190E?
Where and how do you change the fuse for the dash bord lighting sytem in the 1993 190e 2.3l
Did the 1987 Mercedes-Benz 190D come with an airbag?
i have an 1987 190E which comes with an airbag
How come the overhead light does not come on in a Mercedes 190E The fuses are fine and the light is fine.?
Switch may be bad
Where is the oxygen sensor located on a 1989 Mercedes 190E 2.6?
The oxygen sensor for my 1989 190E 2.6 is located on top of the exhaust just underneath the passenger side of the car. The wiring from the 02 sensor runs up underneath the passenger side floorboard carpet.
Can you reset the radiator light on the dashboard of a 1991 Mercedes 190e?
Check that you have enough antifreeze in the overflow recovery unit there is a switch inside that lets you know the fluid is low -- the light should go out by it'self if the level is above the sensor
How do you replace the caburetor in a 1992 190e Mercedes-benz?
A Mercedes 190e doesn't have a carburetor. They are fuel injected.
Are parts from a 1987 Mercedes 300e compatible with a Mercedes 1987 190e?
some stuff is, sway bar, wheels, light bezels etc..
Where is the oil filter on a Mercedes Benz 1986 190E?
oil filter on a Mercedes 190E 1986 is in the back of engine
What is the location of a cps on a 1988 Mercedes 190e 2.3?
crank position sensor is between oil filter and starter, follow wire from module
Where is the outside temp sensor for Mercedes 190e 1986?
Located just behind the front license plate. Looks like a little pencil.
Replace radiator on Mercedes 190e?
== ==
How to adjust idle for Mercedes 190E?
First take a look if the ABS light is on, if yes, check your OVP relay.
