Signal 1 is one of 4 warning signals that are used by PAGASA to indicate the strength of a typhoon in the Philippines. Signal 1 is the least intense of the 4 signals. A typhoon that is this strength will typically cast off winds between 30-60 kph and rains for at least 36 hours.
A signal transduction pathway is a group of proteins that carry out transducing signals (which means it converts signals from outside the cell to a different signal inside the cell). A good example can be viewed when a hormone binds to the receptor in the plasma membrane (outside the cell), the receptor which has now been activated can now interact with intercellular proteins which produce new signals inside the cell.
A buffer amplifier of unity gain is generally used when you need to islolate the source.Connecting a source to an amplifier, can have an affect on the original signal. A buffer amplifier stops the signal being affected by the subsequent amplifier sections. The input to the buffer is matched to the signal impedance.
Yes. Milli means 1/1000.Yes. Milli means 1/1000.Yes. Milli means 1/1000.Yes. Milli means 1/1000.
1000. Milli means 1/1000.1000. Milli means 1/1000.1000. Milli means 1/1000.1000. Milli means 1/1000.
GPS signal jammers are portable devices that literally means gadgets that stop a GPS tracking device from receiving the signal that without which they cannot pick up their position. They emit their own signal at the frequency that GPS tracking devices use, which confuses or blocks other GPS signals.
a dash signal means through
It means the signal is not modulated.
bit means a signal that goes around every where.
Code 7 means 3 diffrent things # TP Sensor{2} # M/T Clutch Switch Signal{1} # A/T Shift Position Signal{1}
Digital signals are "forced" to be either 1 or 0, whereas analog signals are not. This means that a signal of 0.8 will be pushed to 1 in a digital signal and will remain 0.8 in an analog signal, and 0.2 will be 0 digital and 0.2 analog. This means that in order to overwhelm a digital signal the noise must do much more work to be effective. digital signal have only two states analog have infinite states therefore more susceptible to noise
If the values are only 0 and 1 then the signal is digital.
It means that, as the signal travels over the wire, it will (a) get weaker, and (b) the signal for the individual bits will "spread out" until they overlap with the neighboring bits.It means that, as the signal travels over the wire, it will (a) get weaker, and (b) the signal for the individual bits will "spread out" until they overlap with the neighboring bits.It means that, as the signal travels over the wire, it will (a) get weaker, and (b) the signal for the individual bits will "spread out" until they overlap with the neighboring bits.It means that, as the signal travels over the wire, it will (a) get weaker, and (b) the signal for the individual bits will "spread out" until they overlap with the neighboring bits.
it means that the signal on the lapop is going from the screen and its going up for faster signal.
current to preesure converter means....current signal to pneumatic signal...
It means you have weak siganl.
'Viesti' means in Finnish 'message', 'note, or a 'signal'
It means your turn signal bulb burnt out.