Want this question answered?
There are a total of 6 bolts, 3 on each side. They are connected to brackets located toward the middle of the bumper. If you look under the front you will see the three bolts on each side. They are attached to the brackets in a triangle shape if that will give you an idea what to look for. They are big I believe 15mm or so
First you are going to need the following before you attempt to try the job. I just did this on my 01 sierra it isn't that bad. You are going to need the 03 bumper, 03 bumper cover, 03 bumper brackets they are all completely different, and the 03 grille( the 01 grille will fit but will look very goofy). you are going to leave the factory brackets on the frame. Then put the main center brackets on the bumper its self and line up the brackets with the frame and mark spots where you are going to drill holes. Then hook bumper cover to bumper and hook it all up. What i did was go to a car lot that had a 03-06 sierra and took pictures of how the brackets were faced and what length bolts you are going to need to buy. Have fun!!!
a really small loud speaker in or near the front bumper
No it wont. The durango bumper wraps around the side. it might have similar brackets but the bumper design is completly different. Even if it did bolt up it would look pretty funny.
Front drivers side. Mounted on the metal bumper, behind the bumper cover, towards the right front tire. Look under the front end, look up and you'll see it.
They are near the front headlights, under the front bumper. You Can see them if you look.
If you open the bonnet, then look down behind the front bumper, it is normally right in the middle of the bumper just in front of the radiator
There are 3 on each side. 2 in front of axle are visible in brackets off frame rail. Last one is between axle and rear bumper in frame (look up through hole to find it).
The serial number on my 1999 400ex us on the front right behind the front bumper. Stand in front of the fourwheeler and look down on the frame it is stamped in a piece of metal behing the front bumper
yes. to convert the front end of any 00-02 style neon to a 03-05 style you will just need the newer headlamps and a front bumper. the hood and fenders are the same. unless you want it to look like an srt-4. you'll need the srt-4 hood and bumper and lights.
they are susally behind the front bumper, just get under your car and look behind the bumper you should see it
Look behind the front bumper on the driver's side. It should be there.