I'll try and tell you where its at.if you look up at the brake petal see if you can find where the rod from the master cylinder hooks onto the pedal,and that is where you will find it.you will prolly have to stand on your head to do this as it is a real pain but if you just remember to put everything back you will be fine,hope this helps
Defective or out of adjustment brake light switch.
the brake light switch is mounted above the brake pedal on the metal lever
Could be, a blown fuse, burned out bulbs, bad brake light switch, or an improperly installed brake light switch.
check brake light switch on brake pedal maybe getting bad
The switch isn't repairable and should be replaced if bad. It's located on the bar where the brake pedal is attached.
Could be bad brakelight switch or blown fuse
Look at the upper end of the brake pedal under the dash area
check the brake light switch. located on the brake pedal it may be bad
WikiAnswers does not have pictures available.
Usually located at the upper end of the brake pedal under dash area
Those tail lights could be the brake lights you are seeing and that would be a faulty brake light switch or the brake light switch is out of adjustment.
check the brake light switch it might be sticking. located under the dash connected to the brake pedal
It could be a bad brake light switch. You have to step on the brake to shift it out of park.
Did you check the switch on the brake pedal assembly?
The rear lights of your car will still on even if your car was off because the switch was turned on and it will still remain on until the battery's out. Another possibility, if the headlight switch is off and the ignition switch is off, the brake light switch may be out of adjustment or broken and what you're seeing is the brake lights on.
Try spraying the brake light switch with WD-40 first. If that doesn't fix the situation, then: . Remove the under-dash panel. . Locate the switch near the top of the brake pedal and disconnect the wiring harness. . Remove the switch retaining pin and the white nylon washer from the brake pedal pin, then slide the brake light switch and pushrod off far enough for the outer hole of the switch to clear the pin. . Slide the switch down to remove it.
check the brake light switch above the brake pedal
The brake switch is 1/2 way up the brake pedal arm where the rod that goes through the firewall is connected. There is a plastic switch wired into the electrical system that detects when the brake pedal is pushed. My brakes lights (all three) stopped working recently and it wasn't a fuse; if I jiggle the switch by reaching my hand under the dash and pulling on the switch, the brake lights will come up, but the switch is not working when brake pedal is depressed. I should have paid more attention when I removed the switch because it took me 30 minutes in a contorted position to figure out the correct way to reinstall it. I guess I'm off to Ford to by a replacement....
It may be because you are braking.
Check bulbs Check sockets for Hot and Ground Check fuse Check brake light switch
bad brake light switch
Blown fuse or defective brake light switch.
Sounds like it could be a problem with your brake light switch mounted on the arm of your brake pedal under the dash.
where is brake light switch
Assuming you have the lights turned off, you are seeing the brake lights. They are more than likely on because the brake light switch is defective or out of adjustment.