I have a 2001 2.0L and it is on the back side of the engine under the intake manifold. (drivers side) Looks like a large piece of aluminum and is held on to the engine with 2 bolts. This is fairly difficult to remove since the bolts cannot be seen.
An EGR valve is round on the bottom. A metal L looking piece is located on the top. The EGR valve is important in keeping your car running more efficiently.
The EGR Valve on a 2006 Corolla is located on the driver's side of the motor at the very top of the valve cover. Look for a disk shaped valve that kind of looks like a flying saucer. It has two small hoses coming off of it that are connected to the EGR Valve Modulator.
The EGR Valve on a 2006 Corolla is located on the driver's side of the motor at the very top of the valve cover. Look for a disk shaped valve that kind of looks like a flying saucer. It has two small hoses coming off of it that are connected to the EGR Valve Modulator.
Egr valve does not cause stalling. it does not open at idle. I would look at oxygen sensor, then check the gas for water. The EGR can be cleaned, but my EGR valve is 10 years old and did not need cleaning. Also look at plugs and wires.
EGR valve, tube, sensor, or canistor? The Egr system returns unburnt fuel to the engine through the manifold from the exhaust pipe Look for a knobby type thing like a propane regulator on the left side of the engine, that's the EGR valve
a 93 tercel which most likey has a the stock 3e-e engine doesnt have an egr system.
Depends on the year. Here is a site that has pictures of an EGR valve for a 1997 - 1999 Suburban: http://www.racepages.com/products/?D=gmc+suburban+egr+valve&Nty=1&Ntx=mode+matchallpartial&Ntk=Main&N=4294950670+4294963366+9926&Dx=mode+matchallpartial&Ntt=gmc+suburban+egr+valve Go to www.racepages.com and search for an EGR valve for your year rig.
93 Roadmaster.... that's a 5.7L engine, right? It should be attached to the intake with 2 bolts. Look for the thing that looks like a Chevy Smallblock EGR valve. Also, if you're replacing the valve because you have an EGR code make sure you don't have a clogged passage in the intake acting like a bad valve.
The EGR Valve is located in the engine compartment on the Ford Focus. The EGR Valve is set almost dead center into the top of the motor. The EGR Valve looks like a small carburetor with caps on the top and sides.
EGR is on the top of the engine next to the throttle body. If your looking at the engine from the front. It would be to the right of the black valve cover and to the back. That is the egr valve, from 1994 and up the egr solenoid is located under the car above the starter.
The EGR valve is located at the front of the h22a4 engine. The EGR valve is right beside of the front of the EGR valve.
tell me where is the egr valve located please the egr valve is usually located on the top right of the intake manifold on top of the engine so if your facing the engine, look down to your right