answersLogoWhite

0


Best Answer

IT means the cruise control hose is letting in air its located were the throttle is you will see a round ball {black} may need replacing and computer reboot

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What does the fuel 22 fail code mean for a 92 Jaguar Sovereign?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does fuel fail 17 mean on a Jaguar?

It is the code for the TPS Throttle position sensor


What does a Fuel Fail 47 code mean on a 1993 Jaguar XJ6?

Fuel Fail 47 Idle speed contol valve - coil 2: Open or short circuit.


1994 jaguar xj6 vcw code 48 fuel fail?

This means Idle speed control motor (ISC) or valve


What is the fuel fail 44 code mean for a Jaguar Sovereign?

im 99.9% sure its for the oxegen/lambert scensor. mine wouldnt start today but i managed to get it going and i think i need to replace the scensor. the discription of what the a faulty scensor does and what my car is doing match so it must be that.


What if your jaguar xj6 vcm says fuel fail 47?

Fuel Fail 37 is either a fault with the EGR Valve or its Solenoid


1991 Jaguar XJ6 VCM fault code 89 fuel fail what does it mean?

Evaporative canister purge control valve circuit fault


Where is the fuel filler door release on 1988 Jaguar Sovereign?

Just Push down on it, it will pop up


Fuel fail 29 on 1991 xj6 jaguar?

low battery. had battery tested load type. faild replaced battery fix code 29 thank you


What does fuel fail 22 mean on a 1990 jaguar xj6?

Ignition Amplifier Failure


1991 Jaguar XJ6 VCM fault code 69 fuel fail what does it mean?

I own a 91' XJ6 also and i believe when that code comes up it is as simple as your gas cap not being on all the way


Fuel failure code 4 on 1988 jaguar xj6?

o2 sensor fuel too rich


What does VCM code fuel 44 fail 44 mean on 1993 jaguar xj6?

In 1990-1994 XJ6 the VCM Code 44 is the code for the O2 sensor, either rich or lean exhaust has been detected and is causing the code to trigger. It could indicate a bad O2 sensor.