0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the shop labor hours to replace a knock sensor on a infiniti q45 1997?
"http://wiki.answers.com/Q/What_is_the_shop_labor_hours_to_replace_a_knock_sensor_on_a_infiniti_q45_1997"
Where Is the Knock Sensor Located on 1997 infiniti q45?
there are 2 of them. bank one and bank two. both are under the upper intake manafold in the center of the motor. I also have the 97 q45 and just replaced both of mine. real pain. have fun
Where to find knock sensor in a 1997 Chevy Lumina?
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
Where is the knock sensor on a 1997 thaoe?
location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine
Where is the 1997 Saturn SL knock sensor located and how do you replace it?
The 1997 Saturn knock?æsensor is located on the back of the engine. The knock sensor can be removed by removing the wiring harness and the retaining bolts.
Does a 1997 Ford Taurus sho have a knock sensor?
Yes , one of Ford's websites lists a knock sensor for the 3.4 liter SHO engine in a 1997 Ford Taurus
1997 inifinite Q45 will not start?
1997 inifinite Q45 will not start?
Where is thermostat on a 1997 infinity q45?
Where is the thermostaton a 1997 infiniti q45
Where is the knock sensor on a 1997 expedition?
it is in where the timing chain is. mike
Does 1997 ford ranger 2.3 have a knock sensor?
Yes, there is a knock sensor on the 2.3L. It is located on the rear driver's side of the cylinder head.
Where is the knoock sensor on a 1997 Nissan Maxima?
The knock sensor is located below the intake manifold
How many knock sensors on a 1997 Cadillac eldorado and where are they located?
One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
