what happens if the transaxle range sensor goes bad?
, The backup light switch is part of the Transaxle Range Switch. This switch is mounted mounted on top of the transaxle, which is located on the rear left side of the engine compartment. The left side is the side as if you were sitting in the vehicle, so if you were in front of the van looking into the engine compartment, then that would be on your right. One other note: In some of these vans, the transaxle range switch is used to close the backup lamp relay, with is located on the right side of the steering column, behind the instrument panel. These are "export" models, which are made for use outside of the United States. Good Luck in your troubleshooting process, Greg
On top left side of the transaxle..just follow the gear shifter cable. It is also called the transmission range sensor
Goto http://www.hmaservice.com this is Hyundia's repair website. You'll have to sign up... it's free and Search for "Back-Up Lamps Schematic" or "Electrical Troubleshooting Manuals - Back Up Lamps" This will give you the wiring diagram. . CIRCUIT DESCRIPTION With the ignition switch in ON or START, battery voltage is applied from fuse 9 to the back up lamp switch (manual transaxle) or the transaxle range switch (automatic transaxle). With the transaxle in reverse, battery voltage is applied to the back up lamps and the back up lamps go on. there is a switch on top of the tranny its quite commoin on the accents it will cost ya about 13 dollara
The switch is located on the nosecone of the transaxle, look on the front (the side furthest from the engine) of the transaxle near where the shifter linkage is. You will see electrical wires going to the backup light switch.
Front of the transmission.
On the transaxle,just follow the shift cable.
Its located on the drivers side of the transaxle.
P0705 is the code for the transaxle range signal malfunction. It can be caused by faulty park/neutral position switch, misadjusted park/neutral position switch, the park/neutral position switch harness shorted or the park/neutral position switch circuit having a poor electrical connection. Try changing out the switch.
The safety neutral switch on a 1989 Nissan Pickup with an automatic transmission and a D-24 engine is located on the transaxle. The neutral switch will be found where the linkage attaches to the transaxle unit.
The 1993 Buick Le Sabre comes with a 4T60E transaxle. Go to the driver's side fender and lean over. The PRNDL switch is located on the back part of the transaxle where the engine meets with the transaxle. If you look down past your brake booster towards the transaxle you should be able to see it. It should have two sets of wire harnesses coming out of it as well as the shifter arm connected to it.
The tcc switch (tcc brake switch) is located under the dash near the brake pedal. The tcc solenoid is located under the side cover in the transmission/transaxle. The tcc switch (tcc brake switch) is located under the dash near the brake pedal. The tcc solenoid is located under the side cover in the transmission/transaxle. The tcc switch (tcc brake switch) is located under the dash near the brake pedal. The tcc solenoid is located under the side cover in the transmission/transaxle.