0
What does the water temperature switch do on a 1989 Mazda B2200?
Wiki User
∙ 11y ago
A good explanation?Well first it registers the temperature on the gauge in the truck.So you know when it is running too hot,or if not maybe too cold indicating a possible problem with a heater core,radiator,waterpump not working correct.Next the water temp is a crucial part of how the truck runs,and works with the emissions system to make sure the carburetor idles up,when cold and idles down to normal once warm.All of this is important and this can affect the truck alot,on emissions,and generally function and mpg for that matter.If your gauge is not working because the sending unit is defective,or a bad connection I suggest replacing the part.It is mounted directly below the thermostat housing close to the upper radiator hose.It is easy to replace and draining the cooling system is required.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the location of the water pump on a 1990 Mazda B2200 pickup?
behind the radiator,in the middle of the engine
How do you know if the water pump is bad on a b2200 Mazda truck?
she would get hot or leak or you would hear a funny noise in the front
How do you replace water pump on a 1987 Mazda B2200?
DRAIN AND REMOVE RADIATOR.SHROUD AND FAN REMOVE WATER PUMP,RE-INSTALL PUMP WITH SILICONE SEALENT..GOOD LUCK ..toro2
Where is the Mazda B2200 water temp sender?
It is located at the thermostat housing single wire plug and the upper radiator hose goes to the housing to keep it simple.
Why doesnt heater work on 1991 Mazda b2200?
Low coolant? Defective thermostat? Heater core plugged, restricted, or air bound Water pump not circulating coolant?
Where is the EGR valve on 2002 Mazda millenia?
The EGR valve is connected above the water hose on the 2002 Mazda Millennia. The EGR valve is responsible for lowering the temperature of the fuel.
What does a vehicle thermostat do?
It regulates the temperature of the water in the radiator and tells the fan when to switch on to start cooling or to switch off if its too cool. Engines have an optimum running temperature, and the Thermostat helps keep it at that.
Where is the temperature control switch for the cooling fan1992 ford escort lxlocated?
There is no temperature control switch for the cooling fans. The PCM Power control module receives input from the temperature sensor on the water outlet housing. The PCM turns on the fans when the temperature reaches 210 degrees through the CCRM.
Where is the water pump located in a Mazda millenia?
where is the water pump located in Mazda millenia
Where is the temperature switch located at at on a Porsche 944?
Which temperature switch, there are 2. One is the DME temp switch and that one is close to the water inlet at the top of the motor and usually has a blue connector. The dash sensor is located in the middle of the block under the intake manifold and is a single wire sensor.
Where is water temperature Mazda miata?
the water temp sensor in the earlier NA models are at the coolant neck in front of the engine. it's the plug pointing straight up on the 90-93s.
Is there a method to link the mass of water and the temperature rise?
1. Measure out 1 kg of cold water into a large beaker. 2. Measure and record the initial temperature of the water. 3. Put an immersion heater into the water and switch on for a fixed period of time, eg 10 minutes. 4. Measure and record the temperature at the end. 5. Work out the change in temperature. 6. Repeat for several other masses of water.
