I believe that wire is for the key is in the ignition warning buzzer! Not 100%, but 90%.
The 1991 Mercury Sable ignition switch is held in place with a retaining ring. Loosen the retaining ring. Pull the ignition switch out. Remove the wiring harness from the rear of the ignition switch. Reverse the process to install the new ignition switch.
Where is ignition control module on a 2001 mercury sable
location for fuse, and relay switch on a Mercury Sable
how do i change out a power steering switch on a 2001 mercury sable with a 3.0 engine?
The 1993 Mercury Sable backup light relay switch can be found beneath the drivers side dashboard. The backup light relay switch will be above the accelerator pedal.
On a 1996 Mercury Sable : The fuel pump shut off switch ( inertia switch ) is in the trunk , behind the trunk liner on the passenger side ( there is an access hole )
Make sure the switch is plugged up correctly, and not up or down just A little,,,,,,,,,,,,,,, If correct, you got the wrong switch.
On a 1999 Mercury Sable wagon : The fuel pump shut off switch ( inertia switch ) is in the cargo area , behind the service panel on the passenger side
In a 1999 Mercury Sable the fuel pump shut off switch ( inertia switch ) is located behind the trunk liner , on the right side ( passenger side ) There is an access hole
On a 2003 Mercury Sable sedan : The fuel pump inertia switch ( shut off switch ) is in the trunk , on the passenger side of the trunk , behind the trunk liner ( there is an access hole )
under dash on drivers side
I have the same problem on my 95 Sable LTS