0
What else can I help you with?
How can you check the Engine Coolant Temperature sensor on my 91 Honda Prelude SI 2.1L?
How can I check the ENGINE COOLANT TEMPERATURE (ECT) sensor on my 1991 HONDA PRELUDE SI 2.1L
What size engine does 1991 Honda Prelude sr have?
it should have a b21. 2.1L.
Where is the sensor for the engine coolant on a 1991 Ford Probe lx?
The sensor for the engine coolant on a 1991 Ford Probe LX is inside of the coolant tank. There is a lever, and when the fluid gets below this lever, it signals to be checked. It should be refilled.
Will a 2000 Honda Prelude engine fit into a 1991 Honda Accord?
possibly
How do you replace the engine coolant on a 1991 Honda Civic?
The engine coolant on a 1991 Honda Civic is replaced by turning the drain petcock and releasing the coolant. The filler cap is then removed and coolant added until the system is full again.
How do you drain antifreeze on 1991 prelude?
To drain the antifreeze on a 1991 Honda Prelude, first ensure the engine is cool. Locate the radiator drain plug at the bottom of the radiator and place a container underneath to catch the fluid. Open the drain plug and let the antifreeze flow out completely. After draining, close the plug and refill the system with fresh coolant as needed.
Where is the coolant temperature sensor located on a 1991 Honda prelude Si?
one is located at the thermostat housing. the other is in the bottom of the radiator.
Where could a 91 prelude leak coolant on the back of the motor above oil filter?
A 1991 Honda Prelude could leak coolant on the back of the motor above the oil filter from several potential sources. Common culprits include a failing head gasket, which can cause coolant to seep into the oil passages, or a cracked engine block. Additionally, a leaking water pump or a deteriorated coolant hose or fitting could also lead to coolant escaping in that area. It's important to inspect these components for cracks, corrosion, or loose connections to pinpoint the source of the leak.
How do you replace a 1991 Honda Prelude head gasket?
To replace the head gasket on a 1991 Honda Prelude, first, disconnect the battery and drain the coolant. Then, remove the intake and exhaust manifolds, along with the cylinder head bolts, to take the cylinder head off. Clean the mating surfaces thoroughly, install the new head gasket, and reassemble the components in the reverse order, ensuring to torque the bolts to the specified settings. Finally, refill the coolant and check for leaks before starting the engine.
Where is the coolant temperature sensor on a 1991 12 valve cummins?
On a 1991 12-valve Cummins engine, the coolant temperature sensor is located on the engine block, near the thermostat housing. It is typically found on the driver's side of the engine, towards the rear, and is screwed into the block. This sensor monitors the engine's coolant temperature and sends the information to the engine control unit or gauge.
Does a 1991 civic have an engine coolant drain plug?
yes it does but under refrigirator
Where is the engine coolant drain plug on a 1991 escort?
Its an hexagonal plug below the exhaust manifold on the side of the engine.
