Location 30 ; 10A fuse; Labeled "Parking lamps" in manual.
Just replaced mine and my tail lights, dashboard lights, parking lights, and the dinging that goes off when the lights are on all came back. I had to remove the CD Storage box (push two tabs on the inside inwards and pull box out), pulled out #30 fuse (not #32 as I saw on other posts), saw that the wire was broken, put in a new one, tested the parking lights, and all good. Hope this helps. -Swen
Check the position of the manual switch on the main light first, it may be in the OFF position
Amber warning light on ford focus
Because on the door open light is a switch which says " on-off-door". Apparently yours is in the "on" position which will, in time, run your battery down.
A bright light lights the slide (a prepared positive cut from the original film). The light travels through a lens to focus it and on to a screen. There are many mechanisms to change slides, from manual insertion, to rotary and linear slide trays.
i have light that lights up with a car symbol that shows that maybe the light or out don't know what it is.
In flood lights,the source of light is placed between the pole and focus of a concave mirror so as to obtain a diverging beam of light..
The brake light switch might not be connected properly. Remove the brake light switch for 10 seconds and replace it to its original position.
If your car has daytime running lights (standard in Canada) then the only way to turn on just the parking lights is when the car is in park or neutral, the light switch is in the park light position and the parking brake is on. Then the headlights will turn off. Any other configuration means the headlights will be on. On this car, parking lights can truly only be used when parked!
To change the position of a light on a 2007 KIA Rondo you need to access the light. Once you have access to the light, you can move the lights slightly up or down.
try to turn the interior light switch off near the the headlight switch ( dimmer switch) is most likely in the on position
Go to NAPA and buy a Repair Manual.
The position lights on my XC70 are the bulbs just above the taillights/brakelights on the rear of the car. I have one that is often going out and generating the position light message. I usually just rap the brakelight area with my fist and the light pops back on. I guess there is a loose connection in there.