The gas making the popping noise is hydrogen.
No it doesnt explode :P
i think willy gas
Hydrogen.
How do you relight a natural gas pilot light?
An incandescent light uses electric current passing through a wire with a high resistance to current flow. That makes the wire very hot and it glows, producing the light. A fluorescent light uses electricity to charge a gas in a tube. The charged gas glows, producing the light. For the same amount of light, more electricity is needed in an incandescent light than in a fluorescent light, but developing and building fluorescent lights required more advanced technology than did incandescent lights.
A flourescent lamp is a gas-discharge lamp that uses electricity to excite mercury vapor in argon or neon gas, resulting in a plasma that produces short-wave ultraviolet light. This light then causes a phosphor to fluoresce, producing visible light.
hydrogen gas is H2 When H2 reacts with oxygen and fire (energy) It is combustion H2+ 02= 2(H20) Which is water. In that state it is water vapor. A popping noise is also made. That is water vapor racing out. The burning splint tests, basically, is when an individual lights a splint. On lighting this splint, it should be placed near a bottle containing hydrogen gas [ H2 ]. On carrying out this action, the glowing splint may increase in size, regarding the size of the flame, that is. The Hydrogen gas, on the other hand, will make a popping sound. The intensity of the 'pop' will depend on the amount of Hydrogen gas collected in the bottle. Take care to ensure that no Hydrogen gas escapes, or is released from the bottle, until the splint is placed, at least 2 inches away from the opening of the bottle.
You should check if the gas works and that the air hole is closed then you light it .You will need to use a match to light it.If it doesn't light the rubber tubing might be blocked or the gas does not work.
You can test the presence of hydrogen gas by using a burning splint and if the gas makes a "popping" noise
Get a tune up....the popping noise is caused by excess fuel being burned in the exhaust system,you cant hear it until you take your foot off the gas and the back pressure is reduced...
We hear a popping sound because of the presence of hydrogen gas and hydrogen gas burns completely when exposed to fire.
This be a wide range of things does it make the noise when the vehicle is in park and you rev up the engine ? It could be a heat shield on the exhaust system. it does not make the noise if it is just idling....but if you press the gas it makes a noise and when ur driving it makes noise. But I had to put a flang where the header conects to the exaust cuz it was leaking and i thought that was where the noise was comin from but its still makin the noise.
no it does not
it just does. makes a noise. doesnt make a noise. it has to release the gas somehow or it will die. LOL.
If your Gas tank is not empty, you may have a problem with your starter.
Some people pass gas loud because they push it out hard.
take a lighted splint (match) and place beside the test tube. If a squeaky pop sound is made then it is hydrogen
because you light the splint and if there is a squeaky pop noise there is hydrogen gas in the air
If it is front wheel drive is can be a bad CV joint but you should hear a popping noise if that is the case.
You don't have to remove the fuse,just remove the module that makes the sound. It is usually a square black module about 1 inch square.Just run the car low on gas and listen for the sound under the dash and pull the module out