Want this question answered?
the idle jet in the carb is blocked and needs to be cleaned out and reset
Most likely the ignition module.
Change idle speed contol sensor Uncool the battery for five minutes to reset the computer.
Idle Air Control Valve.
Usually, a jeep's engine stalls in idle mode because of a battery power fault or because there is no gas. However, it is common for any car to stall when it has not been running for a period of time and the engine is cold.
Water in fuel, May need to change the fuel filter.
My best guess is that the Idle Air Control (IAC) valve may need to be replaced.
Idle Air Control Valve would be a good place to start.
belt is loose.
I just had this problem on a jeep and it is either the idle is too low or the altinator is bad
if you are trying to change it while it is running it always needs an earth for the ecu otherwise there should not be any reason connected with the battery to cause idle problem
Trouble code P0560 means: System Voltage malfunction or battery backup line malfunction. This has lead to low or idle speed stalls.