answersLogoWhite

0


Best Answer

There was a manufacturing problem with the original equipment brake light sockets which allowed many to fail prematurely. Saturn attempted to replace all of the brake light assemblies through a recall campaign. If your brake light assembly has not already been replaced, contact your local Saturn dealer.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What happened to the brake bulb sockets in the 2002 L series Saturn?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does the tail lights work but not the brake lights in a 02 Saturn l200?

there could be a brake light switch located around the brake pedal, this commonly wears out on a Chevy truck The brake sockets are no good There was a campaign for updated brake sockets. Has it been done by a Saturn dealer? If not get it done and you should be fine


Replace brake light bulb in Saturn LS1?

There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.


Where is the brake light switch located on the Saturn L series?

On the undwerside of the dash attached to the brake pedal.


What if the brake light in the rear window is working but the brake lights on the rear of the car are not working?

Bulbs blown, or corroded sockets.


You have replaced the bulbs and the brake switch still no bottom brake lights on a 95 Chevy lumina?

Check sockets and grounds


Where can you get a brake line diagram for a 93 Saturn SC2?

Saturn repail manual


Why your brake lights are not working and you have changed all bulbs and fuses and brake pedal switch What could be the problem on my 2000 Pontiac grand prix?

Are you getting power to/through the switch? Sockets grounded? Open wire to the sockets?


Why dont The brake lights on my 1966 Mustang not work and I have already replaced the switch?

Check the bulbs- they are double filamented with the smaller for brake lights Check the fuse Check the sockets for power and ground Check the sockets for corrosion


When I press the brake pedal in my 1996 Saturn SL the instrument cluster lights up and at night it gets brighter when you brake any ideas?

It's a ground fault in one or both of the brake lights. Instead of brake light voltage going across the bulb and to vehicle ground, it's going across the brake light then back across the tail-light and into the tail light/dash light circuit. Check the brake light sockets first. Saturn had some problems with some of their tail light assemblies corroding from too much heat when lights were on for an extended period of time. You might be able to just clean up the connections in the tail light assembly then put it all back together with a little of the special grease that they use for light sockets. If that's not it, check the ground wire and make sure it's getting a good connection.


1996 Saturn brake pad minimum thickness?

Just buy new brake pads.


Brake lights dont work checked the bulbs fuse and replaced the pedal switch what else can you check?

check that you're getting dc voltage to the brake bulb sockets. also, clean out and replace any old electrical grease at the bulb's sockets.


Is there a diagram of the rear brake shoes of a 1999 Saturn SC1?

Yes, there is a diagram of the rear brake shoes of the 1999 Saturn SC1. It is found in the cars maintenance or repair manual.