Depends on what you mean by too much. If you overfilled it by say 1 pint then more than likely no damage will be done. Simply drain out the excess. If, however you overfilled it by more than that then serious damage can occur. The crankshaft can make contact with the excess oil and whip it into a froth. This froth of oil mixed with air is a poor lubricant and will provide far less protection from wear than 100% oil. Drain out the excess immediately.
not much, it just makes it harder to start when the engine is warm. but diesel in a petrol car...do not start or it wil destroy it
the motor gets lubricated.
I assume you mean add fuel by pressing the accelerator. In which case the engine runs faster.
If you run it that way you will cause internal damage.
The engine dipstick is the only tool you can use to measure how much oil is in the engine.
Does not effect engine's output.
It will not hurt the engine what so ever, But it will make it smoke and might fowl out a spark plug.
The amount needed will depend on how long the pan was off. Start with three quarts, start engine, shift through drive and reverse. You the check the level idling in neutral. Add fluid slowly until at proper level.
No distance! You can seize up the engine and require a total engine replacement. Don't even run the engine, but get a qualified individual to look at it. You may simply need to add oil to the engine.
There is software you can buy to add a Blu Ray drive to your computer. However, many software systems are only compatible with specific computers, so you should figure out if the one you want will work with your computer.
it will go cold
The slide can get damaged.