Nothing bad will happen with a simple lamp; it doesn't really care which way electricity is flowing through it. For more advanced electronics, changing poles could have other adverse effects.
Note that this refers to the lamp alone. Also make sure the armature you are placing the lamp inside does not give you surprises from connecting your active ground to things you don't want it to.
If there is no ground wire connect the ground wire to the neutral wire.
A NEMA 5-20 plug is a standard 3 prong plug. It wires the same as a NEMA 5-15 plug (Ground wire to the "D" contact, Hot to vertical terminal and neutral to the horizontal terminal (with the Ground terminal either at the top or bottom)).A 5-20P plug has the neutral blade rotated 90°. The 5-20R receptacle usually has a T-shaped neutral hole, to accept both 5-15P and 5-20P plugs.
The end sockets have to be rewired. The schematic for the rewire is on the ballast label.
The usual procedure is to remove the old wire and replace it with new wire.
coil on side of fly wheel broke of can refit but want to rewire bike from start to finish key start to cut of switch to coil whole bike but need to know lay out of wiring of bike and replace all wireing
If there is no ground wire connect the ground wire to the neutral wire.
Very often the ground wire in the fixture is ignored, or just connected to the box, if there isn't a conductor to connect to. This, however, is a code violation as any fixture with a ground wire is required to have it properly connected to an equipment grounding conductor back to the panel. This is for YOUR SAFETY. Technically you should rewire the circuit with the proper conductors. It is BAD PRACTICE to connect the ground wire to the neutral or white wire because this could create a hazard of its own.
A NEMA 5-20 plug is a standard 3 prong plug. It wires the same as a NEMA 5-15 plug (Ground wire to the "D" contact, Hot to vertical terminal and neutral to the horizontal terminal (with the Ground terminal either at the top or bottom)).A 5-20P plug has the neutral blade rotated 90°. The 5-20R receptacle usually has a T-shaped neutral hole, to accept both 5-15P and 5-20P plugs.
I always connect the ground wire to the box. However, if there is no real ground wire running back to the panel it really does you no good. The NEC requires that you rewire the circuit with the proper conductors. Remember that the ground is for your protection. Without a proper ground, you run the risk of injury or death if the fixture wiring fails.
eHow is a great resource for topics like this, with articles like "How to Re-Wire a Lamp," "How to Rewire a Lamp with a Rotary Switch," "How to Rewire an Old Lamp," and "How to Wire a Floor Lamp."
Rewiring is easy
which model?
Yes, if you rewire the bed and rewire the plug on the wall to 220 volts.
Type your answer here... Why are you wanting to rewire the brake lights?
The end sockets have to be rewired. The schematic for the rewire is on the ballast label.
a while
Go to Road Race Enginiering they have a page on how to rewire the CAS