1 the whole wheel can fall off causing a wreck.
2 it will cause a fire from friction possibly causing a wreck.
3 it will waste a lot of your gas.
4 it can lock up the whole wheel causing a wreck.
5 it will make grinding and whirring sounds.
Might be that the nut holding the wheel bearing needs tightening or that the wheel bearing needs replacing. Going to have to take it apart to get to the bottom of this one.
No, you should not. You are either tightening the wheel bearing to tightly or too loosely or the bearing race needs replacing. Take the vehicle to a professional and see what is wrong.
Begin by removing the tire and wheel. Remove the and of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install your new wheel bearing.
no need to replace wheel bearing unless the wheel bearing is worn out
Front wheel bearing needs immediate replacing.
replacing rear wheel bearings on frontera B
You should inspect them. They should be smooth, without pits or scores and sit reasonably in the races. If they are not you should replace them or find a garage where they would do it.
A grinding or abnormal noise at the wheel is a good sign the bearing is bad. Unload the bearing by moving the vehicle left or right while moving. If the noise comes and goes when doing this, the bearing is bad. The only positive way to verify this is to remove the bearing and look at it. Pitting, scouring, and any other signs of wear indicate the bearing needs replacing. Be sure and replace the race if it is not perfect.
Most front wheel drive bearing hubs can not be greased. --thats ridiculous, your wheel bearing HAS to be greased. you either buy it in a package pre-greased or you BETTER do it yourself ! especially front wheel drive. replacing a wheel bearing is a CHORE, why do it twice becasue you didn't grease it when you fixed it ?
Replacing a wheel bearing in your Chevrolet blazer will cost approximately $175 per bearing. You can save $125 by doing the work yourself.
They very rarely need replacing, just adjusting
Yes. A damage wheel bearing can seize up suddenly, which'd be really bad.