The belt will squeak until the coolant wears off.
It will squeak
Thermostat is located on side of cylinder block, behind coolant inlet housing for lower radiator hose and the generator. drain cooling system. rotate accessory drive belt tensioner clockwise to release tension from accessory drive belt. remove accessory drive belt. remove mounting bolts and generator. disconnect electrical connector from engine coolant temperature switch for removal of coolant inlet housing. remove nuts, coolant inlet housing, thermostat and gasket.
Could cause the belt to slip and the engine to overheat.
They will remove the old belt and install a new one. If the cam belt drives the water pump then you would want that also replaced along with the coolant. If the belt does not drive the water pump then only the belt is replaced.
Disconnect the negative battery cable.Raise the vehicle.Remove the front lower splash shield.Drain the coolant by opening draincock in radiator.Close the radiator draincock.Install the front splash shield.Lower the vehicle.Remove the accessory drive belt.Remove the generator.Remove the heater hoses.Remove the drive belt tensioner boltsRemove the drive belt tensioner.Reverse procedure to install.
Accessory drive belt.Accessory drive belt.
Belt
alternator drive belt?
Most likely: 1-Insufficient amount of coolant (anti-freeze.). 2-Insufficient coolant flow (bad water pump or drive belt.)
The serpentine belt would be the same as the accessory drive belt.
NO. Drive belts drive the AC, Power Steering, Alternator, Waterpump, exe. Cam belt=timing belt.
Belt Drive