Voltage is the pressure that electric current (amps) is pushed by. In any given circuit, wattage (power) is what is used to run an appliance. Wattage is produced by 'pushing' a given amount of current.
However, the material in which the current is pushed (wire) can stand only so much pressure. If you use 240V on a 110V line, the wiring will no doubt burn.
If you attempt to use house current on a 240V rated appliance, you will "over-amp" the device and damage it.
<<>>
If you transpose 240V with 110V and the load is inductive it will not operate. If the load is resistive then you will only get one quarter of the rated wattage if the voltage is reduced by half.
I beg to differ with the statement," If you attempt to use house current on a 240V rated appliance, you will "over-amp" the device and damage it." There are many home appliances that utilize a 240 volt supply. The hot water tank, clothes dryer and cooking range to name a few.
One word: KABOOM.
It would be better if you got a transformer and stepped up the voltage.
Yes, you need a transformer
What is your question? A standard outlet is 110V. A 220 outlet is shaped different so that you know it is 220. You would never run 220 through a 110 outlet.
There are no adptors to plug a 240v plug into a 120v receptacle. 240v requires two hot wores and a neutral and ground. 120v requires one hot wire, a neutral and a ground. If you have something that runs on 240/120 you need the cord and adaptor that came with the equipment as you willl need the wires to mate up accordingly.
no
Using a box that is hire voltage than what you need can cause a short, and even a fire. So using a 240V box, when all you need is a 110v receptacle, wouldn't be a good idea.
One word: KABOOM.
No
It would be better if you got a transformer and stepped up the voltage.
Yes, you need a transformer
No India uses 240V at 50Hz the U.S. uses 110V at 60Hz.
No. Sounds like a fairly hazardous thing to try as well. If it's to use a heater in the US, then buy a US heater at a lower cost than any adaptor that might do the job for you. If it's to use on a UK building site that has 110V but doesn't have 240V, it breaks all the rules because you end up with 240V where you shouldn't.
NO The radio will actually run at about 6 volts via an internal transformer. If you plug it into a 110v supply you will only produce 3 volts which is the same as trying to run it with flat batteries. The only way is to use a 110v to 240v transformer which will be rather large, cumbersome and heavy.
Check your laptops power adapter to see if it will handle both 240v(UK) and 110v(US) if it can handle 240v (which I believe most can) then all you need is a UK plug adapter.
Changing the plug will not change the power needed to run the saw. If the saw has a dual voltage motor then a wiring change can be done to switch the saw from 240 to 110 volts. If it is not a dual voltage system then the saw must be fed with 220 volts.
You need a dedicated circuit for that. You cannot power a 220V device off 110V.