Operating at half the required voltage, the lamp will not operate at full capacity if it comes on at all.
The terminology T8 suggests to me that the fixture is a fluorescent fixture. These types of tube fixtures need a ballast to make the tubes ignite. If you are trying to operate this type of fixture on 220 volts, you will need a ballast that requires a 240 volts input voltage source.
Yes, but it will not work.
Yes, if there is a 208 volt connection on the multi tap ballast. One side of the 208 to the common terminal and the other side of the 208 supply to the 208 volt lead. As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed. Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized. IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
0.016 volt
The timer has to be multi-pole. The ballast must be connected to the load contacts of the timer. If the timer is a 120 Volt timer, the timer has to run on a 120V. circuit. Loads are loads, and as long as you have a multi-load timer you can hook up whatever you want. If the timer only works on a shared power source (load shares the timer supply) you will need to use a contactor on the load side or the timer.
Unless the ballast is a multi tap primary you can not rewire it for 220 volts.
You don't. A ballast with a 347 volt input is a commercial ballast. The 347 volts comes from a 600 volt three phase four wire Y system. You can change the ballast out to a 120 volt and rewire the unit but in most cases it is cheaper to buy a completely new lighting fixture.
Yes, 220 volts is in the same voltage classification as 230 volts.
The terminology T8 suggests to me that the fixture is a fluorescent fixture. These types of tube fixtures need a ballast to make the tubes ignite. If you are trying to operate this type of fixture on 220 volts, you will need a ballast that requires a 240 volts input voltage source.
Not unless you have 277 volts in your garage. Open the fixture and check the ballast. Some of the commercial fixtures have multi tap connections for different voltages. If 120 or 240 volt tap is present then you can use the fixture.
No, not a good idea. You have to use a 347 volt ballast.
Is it incandescent or flourescent? If it's incandescent it will work okay--it'll be dim but it will work. A fluorescent probably wouldn't fire. Now having said that, if this is a European lamp google "110v European base bulbs" and you'll find light bulbs that work on 110v but have bases that screw into European sockets. Just change the plug on the lamp and you're golden.
A 277 volt lighting fixture is one that is usually used in an industrial application. The reason for this is the voltage rating. A voltage potential of 277 volts is the voltage to neutral (ground) of a three phase four wire 480 volt distribution system. 480 volts / 1.73 = 277 volts. Rather than having to add a transformer to the system to provide 120 volts for lighting, manufactures produced a ballast for fluorescent fixtures that operates on the 227 volt potential.
The lamp may not fire. Check the ballast to see if it is a multi tap. Most of the newer ballasts have variable taps for different voltages starting with 120, 208, 240, 277 and 347. This is for the convenience of the customer so as not to have many different ballasts for spares, just one that will do all. A ballast is specific to the lamp wattage.
Probably not much because 6 Volts is not enough to power a 12 Volt coil
A volt is a volt is a volt.
A volt is a volt is a volt.