The current, if connected to a voltage source that can supply the needed current to (R1+R2) R3, will be unchanged.
If the source cannot supply the needed current, the terminal voltage will decrease, which will change the current flowing through R1 and R2.
Home devices are connected in parallel and not in series.
You would get a high circulating current through both cells, possibly enough to do significant damage to both the cells and to you, depending on the capacity of the cells. Technically, they would actually be connected in series, not parallel!
The difference between a series and parallel circuit is that a series circuit is connected in such a way that the same current intensity flows through the elements while a parallel circuit is connected in such a way that the same potential appears across their terminals.
In simple way resistor bank contains number of resistors in series or parallel combination. They are connected in parallel to decrease the resistance and increase current rating and power dissipation.And they are connected in series to increase resistance and power dissipation.
Two batteries, put them in series and either measure the voltage with a voltmeter, or with a fan connected watch the speed increase. A parallel connection will increase the current available but will not have an obvious change in output, as the current available is just that, ready for use. You can do something else with parallel and that is to have a volt meter showing that there is a current flow between the two batteries and that is why batteries connected in parallel will discharge.
Current sources should not be connected in series. It's okay to connect them in parallel.
An ammeter is connected in series. A voltmeter is connected in parallel. ammeter should always be connected in series instead of parallel becoz it is a low resistance device and we know that resistance is inversly proportional to current so more current will pass through it and if it is connected in parallel than it may get damaged
Yes, series and parallel connection of batteries is possible. When connected in series Voltage increases. In parallel, Current increases but voltage is constant.
more current will be in case of parallel because in series combination resistence is greater with respect to parallel combination
a voltage source has very less(negligible)resistance.thus is considered as a short.if connected in parallel to a resistor will draw all the current acting as a short.thus is always connected in series of a resistor.where as a current source has tremendous resistance(infinity).thus if connected in series will be conidered as an open branch and no current will flow through it other than the source current.
current remains same in series while divide itself in parallel circuit
In a series circuit the current flow in each element is equal but voltage across the each element is differ. In a parallel circuit the voltage across the each element is equal but current flow in each element is differ.
The voltmeter will register the volts, the ammeter will either explode or blow a fuse since it has a very low resistance and is designed to be used in series to measure the current flowing through it.
Home devices are connected in parallel and not in series.
Voltmeter should be connected always in parallel to a circuit ANSWER : IT should be in parallel except when used to measure current. Then it should be placed in series across a shunt.
as the given cells have the same current flowing in through them (current flowing through the cells connected in series is equal to the current flowing when connected in parallel ) equate the formula's of cells connected in series and cells connected in parallel.thus by equating we get the value of the internal resistor as 2 ohms.
series