The transmission is a 4t65e, have tech check for code p1811-max adapt, long shift i so, it needs a pressure control solenoid
If any fluid except for the correct transmission fluid is put into the transmission of a car, it will eventually fail. If this happens, a person must flush the transmission of the car.
If you turn off the electric current in the solenoid, the solenoid quits pulling its armature.
You need to replace the starter solenoid .
If the battery tests good and battery cables are clean and tight at both ends and you are jumping the starter solenoid correctly with no results, you probably have a bad starter/solenoid.
A solenoid is a type of magnetic switch responsible for helping your starter motor turn on the engine. When the solenoid sticks, the ignition struggles to start. When this happens, usually your key will "catch" in when you turn it to start the vehicle.
You need a new transmission it will not drive properly
Starter solenoid
Yes. DC can pass through. As it passes through then solenoid would act as if a bar magnet.
I have metal in the transmission pan and the filter is dirty
The transmission will fail.
1972 Plymouth satellite