0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Will two batteries and a wire make a light bulb light?
first of all, you need a bulb, a wire, and ONE light bulb. You clip the wire on the battery and touch the wire on the bottom of the light bulb
If you wired up the circuit with a bulb two batteries and a switch with a thin wire what will happen?
the bulb will light up
How would a meter be connected in a circuit too measure the voltage at a light bulb?
When connecting a volt meter to a light bulb to measure the voltage of the light bulb, run a third wire from where the wire enters the bulb to one terminal of the voltmeter and a fourth wire from the other side of the bulb to the other terminal of the voltmeter.
Describe how a meter would be connected in a circuit too measure the voltage at a light bulb?
When connecting a volt meter to a light bulb to measure the voltage of the light bulb, run a third wire from where the wire enters the bulb to one terminal of the voltmeter and a fourth wire from the other side of the bulb to the other terminal of the voltmeter.
What happen to the bulb when the copper wire connect to the battery?
if the copper wire (s) were conneting the battery to the lamp removing one of the wires would break a circut and the lamp goes out.
What is the wire that gives off light in a light bulb?
In an incandescent light bulb the wire that gives off the light is called the Filament.
What is the resistor inside a light bulb called?
the wire in your light bulb is a resistor :)
What is a wire in a light bulb?
filament
How can lemon make a bulb light?
the Sparks on the copper makes the wire on the light bulb makes the 9v light bulb turn on.
How do you make a battery light a light bulb?
Make a circuit with 2 wires a batery and a light bulb and touch wire to medle on light bulb
Are you supposed to wrap the copper wire around the light bulb when making a potato powered light bulb?
You have to connect one conductor from potato to one terminal on light bulb and the other to the second conductor. Your light bulb must be a low voltage and low current bulb because a potato delivers very little power. Light bulbs that screw in would have one connection point on the screw in part and one at the bottom of the base of the bulb. It would be best to put the bulb in a socket that would allow easier connection of wires instead of trying to wrap the wire around the bulb.
What is the main reason fore a light bulb to stop working?
the main reason for a light bulb to break is, the light bulb heats the tungstin wire. When the tungstin wire gets heated to much it breaks, causing thi light bulb to stop working.
