0
Are you supposed to wrap the copper wire around the light bulb when making a potato powered light bulb?
Wiki User
∙ 14y ago
You have to connect one conductor from potato to one terminal on light bulb and the other to the second conductor. Your light bulb must be a low voltage and low current bulb because a potato delivers very little power. Light bulbs that screw in would have one connection point on the screw in part and one at the bottom of the base of the bulb. It would be best to put the bulb in a socket that would allow easier connection of wires instead of trying to wrap the wire around the bulb.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the use of sulfuric acid in printed circuit board manufacturing?
No acid is used.In the subtractive process for making PC boards, one of two etchant salt solutions will be used to remove copper from where traces are not desired:ferric chlorideammonium persulfateIn the additive process for making PC boards, copper will be added where traces are desired by electroplating from a copper sulfate salt solution.
Why is copper used to make water pipes?
Copper has several redeeming qualities. It last long, does not rust, and won't grow bacteria. It also does not interact with water, making it good for pipes.
Can a copper wire be used as a variable resistor in a circuit?
Because copper is a very good conductor, it isn't used for making the main body of a resistor. The body must be made of high resistance metals, such as nickel and chrome alloys. Copper is only used for making the connecting leads of a resistor.
What type of copper is typically run underground?
Type L or Type K copper pipe is typically used for underground applications. These types of copper pipe have thicker walls than Type M copper pipe, making them more suitable for underground installation where they may be exposed to greater pressure or potential damage. Additionally, this thicker wall helps to prevent corrosion and allows for increased durability underground.
What are the three primary classes of best practices for copper installation?
Fallowing standards, Making sure you do not exceed distance limits and Good installation techniques
What is the pH of copper sulfate?
The pH of a copper sulfate solution depends on its concentration. Typically, a 1% solution of copper sulfate has a pH of around 3-4, making it acidic.
What is copper suitable for?
copper is suitable for making electricty.
Two uses of copper?
Copper is an extremely good conductor of electricity + heat and is also very ductil so Electrical wiring is todays main use of copper. Copper is also commonly used for plumbing pipes to distribute hot and cold water around the home as its excellent at resisting corrosion and is also lightweight,
Affects on household acids on copper?
it affects copper by sending the reaction into the copper and making it become a smaller object
Why does oxygen decrease the conductivity of copper?
Oxygen will make it impure and will react with the copper making it copper oxide, which isnt as conductive as copper alone
What is the in principles in making a balloon powered car?
olivia anna
What was Peter Cooper famous for?
For making the engine powered train
Why is copper suitable for making sauce pan?
It is
What term is used to describe the mixing of copper sulphate and water?
ONe word term is 'Dissolution'. Or Making a solution.
Which metal is used for making wire?
Mostly "COPPER" is used in making wires
What was the wright brothers intention of making an airplane?
To achieve powered flight.
When you making out are you supposed to make noise?
Wth? No!!
