# The engine will rev high and not easily drop back to idle
# The gas pedal will not operate smoothly
I'd say this isn't a very common problem, but the cable is easily accessed at the throttle body for trouble-shooting
A sticking / binding throttle cable is either the throttle body sticking, or the cable itself.
It's pretty easy to disconnect the cable end from the throttle body to be able to figure out which one is sticking/binding.
What you find out will determine which direction to go next - a bent or obstructed cable between the gas pedal and throttle body, or diagnosing the throttle body itself.
The throttle cable is located on top of the throttle body.
A push-pull throttle is a very misunderstood thing. It is a dual cable throttle operation where in the pull cable is what opens the throttle plates. And, the push cable along with a throttle return spring is what closes the throttle plates.
its your idle controle i have a 1992 same problem just havent had time to fix it if you shut the car off for a second it will reset.THE DISENGAGED THROTTLE CABLE CAN INTERFERE WITH THETHROTTLE CAM MECHANISM, RESULTING IN THE THROTTLE STICKING IN EITHER THE OPENPOSITION OR CLOSED POSITION. WHEN THE THROTTLE STICKS IN THE OPEN POSITION,UNWANTED VEHICLE ACCELERATION WILL OCCUR WHICH MAY CAUSE AN ACCIDENT. Remedy: INSPECT THROTTLE CABLES TO ENSURE THE THROTTLE CONTROL CABLE IS FULLY SEATED IN THE RETAINING BRACKET AND INSTALL A CABLE TIE STRAP TO SECURE THE CABLE IN ITS CORRECT SEAT.
The throttle cable is not adjustable.
The throttle cable does not go from the transmission to the throttle body.
There is no adjustment on the throttle cable.
On the throttle body, opposite of where the cable attachOn the throttle body, opposite of where the cable attach
how to replace throttle cable on grizzly 600
I had a stuck throttle on my 1996 Passport. The throttle cable had a piece of protective black rubber around the throttle cable between the outer cable covering and where the cable connects to the throttle body. The rubber had began to come apart and some of it was getting inside the throttle cable covering, causing the throttle cable to bind. I removed the rubber piece and cleaned out the cable by covering it with GOOF-OFF and then sliding the cable in and out until my cleaning rag was clean when I wiped off the cable. I did not replace the rubber piece and have had no problems since.
On the throttle body, opposite of where the cable attach,On the throttle body, opposite of where the cable attach,
There is not speedometer cable on a 1996 Honda Civic. There is a throttle cable. Top replace this unhook it from the throttle body and gas pedal. Hook on the new cable to snake it through the firewall. Properly hook the throttle cable to the gas pedal and throttle body.
Were can I buy a throttle cable for a 97 geo metro