answersLogoWhite

0


Best Answer

Pre-cat, probably run poorly and may lead to damage to the catalytic converter. Post-cat, nothing.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What if the car has been driven for 2 months with a bad 02 sensor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will a bad knock sensor make a 1999 Mercury Villager stop running?

No. The knock sensor alerts you to the fact that there is an engine vibration that needs attention. Mine has been awaiting replacement for six months.


Is your knock sensor bad?

Thanks, no it is just fine. Replaced it a few months ago.


Why does your tach work but not your speedometer on a 92 Jeep Wrangler?

Tach is driven by a motor signal, speedo is from the trans the sensor is bad on the transmission


What are symptoms of a bad camshaft sensor in a 2000 Chevy Tracker?

when my camshaft sensor was going bad, the vehicle refused to crank after being driven and parked for a few minutes. If you wait a little while it may crank. I heard of people pouring water on the sensor casing to crank them also.


What makes the crankshaft position sensor go bad?

what can make a crank shaft sensor keep goin bad even if its been replaced 4 times.. in a 2000 oldsmobile bravada


2001 cadillac catera What would cause a coolant low light although the tank is filled to cold line and the engine is not over heating?

Bad sensor? There is a coolant temp. sensor that goes bad. Mine been on for over a yr doesnt mean it is low....just bad sensor.


How do you know the cam sensor is bad?

how do you k now the cam sensor is bad


What are the symptoms of a bad TDC sensor?

what are the symptoms of bad tdc o2 sensor


Why does my 99 Mitsubishi Galant Idle poorly?

Timing, a bad plug (s), bad plug wires, bad maf sensor, bad map sensor, bad o-2 sensor, bad ign. Module


Why does your 1988 Buick Regal not start when you try to crank it after it has been running?

if it has a crankshaft sensor that's bad


How do reset low tire pressure on 2011 Dodge Journey?

If all tires are at the proper pressure (36 psi) and the vehicle has been driven for 10 minutes above 30 mph, the system will reset itself. If it does not, there is a bad sensor and you will need to take to a mechanic with diagnostic tools to find which one.


How do you know if a crankshaft sensor is going bad on a 1996 Chrysler Sebring convertible?

When a crankshaft sensor is bad the engine will not run. The sensor is not usually intermittent, it is either good or bad.