If that drag link pops out, there'll be a wreck.
a clamp in the shape of a c where you tighten it by twisting the end.
un-tighten the clamp unscrew the bars and then its off put your clamp on the new bars align the wheel tighten the clamp put grips on and intense ride!!!!
underneath the centre console is a clamp in the clamp should be your 2 brake cables that control your handbrake ...you can tighten them there ...use spanner as is a squeeze to get a socket on
Tighten your clamp
tighten the clamp up
loosen the clamp bolts on the adjuster assy and rotate the whole axel using a pipe wrench, when your chain is properly set re tighten clamp bolts.
you have to take off your bars an take out the bolts on the clamp then slide it on the bars refit the bars straighten them up then tighten the clamp.
you can use the c clamp just tighten it slowly
The iron clamp is an iron ring with a bolt and nut to tighten it. It is used in conjunction with an iron stand and is used to elevate equipment.
A screw clamp is something that is used to put a screw in place. There are hand screw clamps where you use your hand to tighten the screw.
Disassemble, clean and reassemble the clamp. Tighten harder. If this fails, get another clamp, or another seat post, depending on the design.
Assuming this is a loose and rattling exhaust heat shield, the more effective repair is to use a large worm drive style hose clamp to tighten it. It may be necessary to use more that one clamp joined together. Put the clamp around the loose area of the heat shield and tighten it.