0
underneath the centre console is a clamp in the clamp should be your 2 brake cables that control your handbrake ...you can tighten them there ...use spanner as is a squeeze to get a socket on
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
2004 Rav4 handbrake lever loose how do you tighten it?
its normally mechnical so find the steel cable and find the nut on the cable of the parking brake "handbrake" and tighten
How do you adjust the back brake on a ford fiesta zetec?
Remove handbrake gator and tighten exposed nut at the end of the handbrake.
How do you tighten a handbrake on saxo?
On a Saxo, the handbrake can sometimes come loose and needs to be tightened. To do so, first turn the engine on and place your foot on the brake. Push in the handbrake button and then pull up on the handbrake until tension is felt. Repeat as needed.
How do you tighten handbrake on Daewoo 1.5?
Directly under the car, in line with the exhaust tubing. : )
How do you tighten handbrake golf mk4 gti?
Remove side covers on rear ashtray and lift out unit. The adjustment nut needs a 10mm spanner. Just about take up any slack when handbrake is off. Don't over tighten.
How do you tighten the handbrake cable on a fiat bravo?
There is a screw on the hand brake handle inside the cabin. Just take off the leather that is covering your handbrake lever, and you will see it.
How do you tighten the handbrake on Hyundai accent 2002?
If the rear brakes are out of adjustment,the hand brake will not work..
How do you adjust 1993 Nissan Micra handbrake?
Put the handbrake on and lift the rubber flap up just below the lever. Beneath that will be a 10mm nut, tighten that to adjust handbrake. 1993 micra should be about 5-7 clicks
How do you tighten fiat cinquecento handbrake cable when its at its limit?
you cant. when its at its limit you must put new rear brake shoes on.
How do you adjust handbrake on a Peugeot 106?
Take off the centre section of the exhaust and the heat shield and behind them you will see the handbrake cable, were the cable goes from two into one there is an adjustment nut to tighten it. Think its 13MM. turn it towards the front of the car to tighten the handbrake. If you have rear drum brakes you could also adjust the handbrake by pushing the shoes out a few clicks but that involves opening the drums and is more complicated.
How do you adjust the handbrake on a 2006 Mazda 6 at both sizes?
the handbrake cable splits into two under neath the car. To adjust the handbrakes, alter the adjusting bold ratio at the bottom and on both sides of the car.... You can also remove the cover off the handbrake cable and tighten to size 10 bold that links the cable to the mechanisim inside the car
Why does the handbrake light come on when the handbrake is down?
it has a sticky handbrake switch
