You can not put E85 Ethanol fuel into a car not designed for it
as the Ethanol fuel (ethyl alcohol), {the same type of alcohol found in Alcoholic Beverages} will destroy the fuel system ( "O" rings , lines, ect...)
How much oil a Daewoo Lanos SE 1998 is used to change the oil in the motor
To check the transmission fluid on a Daewoo Lanos 2000 you have to get to the back side of the engine from underneath. The way we did it was to put the car on a lift.
check your hand book
The jack points on my daewoo lanos look like little cut out notches on the underside of the body. I have a 2001 Y reg model. Hope that helps. There is a good illustration of it in the handbook if you still have it.
did you change your gasket put a new gasket with a silacone tighten the bolts down evenly drive safe
there is a round put on the top corners of the seat. pull the pin up and simply fold the seat down. you will have to move the seat belt to the side to allow the seat to go down also.
In a Daewoo Lanos, power steering fluid is typically added to the power steering reservoir, which is usually located near the engine, towards the front of the vehicle. The reservoir is often labeled and has a cap that can be unscrewed. Make sure to use the correct type of power steering fluid as specified in the owner's manual. Always check the fluid level and top it off if necessary, ensuring not to overfill.
try putting fuel injector cleaner in your gas. its bout 4 bucks a bottle put it in after filling the tank. then drive till your empty to make sure you use all the cleaning agent ( little tip stay close to home or by gas stations) if that don't work. try changing the fuel filter now the last thing it might be is the coil isn't sending a signal to the spark plugs.
To wire a car stereo in a Daewoo Lanos, you'll typically need to connect the stereo harness to the car's wiring. The common color codes are: red for ignition power, yellow for constant power, black for ground, and speaker wires that vary in color. You'll need to match these with the corresponding wires from the stereo harness, ensuring proper connections for left and right speakers. Always use a wiring harness adapter if available to simplify the installation and avoid cutting factory wires.
6.8 qts.
I assume there is not a shut off on the supply side of the line. If you are used to working with gas, you can do it with the line charged, but it is probably best to shut the gas off at the main. If there is not a shut off valve where the flex line connects, I would put one there now. Then it is just a matter of changing the line. Do not use any pipe dope or tape on a gas connection, at least on the flex line. This is a flare fitting and does not require it. The valve to pipe connection is a plumbing connection and should have dope or tape on the threads.
Jack up right hand side of car. remove the plastic covers under the car so can see the belts. once removed loosen the tensioner, slip the belt off and then put new one on and then tighten the tensioner untill belt tight. put covers back on under the car