If the pool is above ground and round, it is designed to carry the pressure of the water when it is level by carrying load as in a hoop. If it is not level, bending loads are produced due to non uniform pressure and the pool could collapse as it is not designed for these loads. If it is off by an inch or so deep over 3 or 4 feet depth that is OK, but Iwould not go much beyond that.
An unbalanced pool could result in corrosion, scale formation, cloudy appearance, swimmer skin and eye irritation, etc. depending on the parameter that is influenced.
To maintain a balanced pool the Langelier's Saturation Index (SI) should be used which will create a balance between the pH, temperature, alkalinity, calcium hardness, and total dissolved solids (TDS) in the pool.
The Langelier Index uses a chart of values for each of the balance factors. If the result of the equation is less than -0.3 then the pool is said to be corrosive (acidic) and if it is greater than 0.3 then it is said to be scale forming (basic)
The Langelier Index: SI = pH + TF + CF + AF + 12.1
TF = temperature factor
CF = calcium hardness factor
AF = alkalinity factor
12.1 = is a constant used for TDS below 1000ppm....if its above use 12.2
What should it all be?
pH = 7.2-7.8
Temperature = 70-90F
Alkalinity = 80-120ppm for pools...120-150ppm for whirlpools
Calcium Hardness = 150-275ppm
Total Disolved Solids = 450-1000ppm...should never exceed 1500ppm
To decrease:
pH - add Muriatic acid
Alkalinity - add Muriatic acid
Calcium hardness - add soft water
To increase:
pH - add Soda ash
Alkalinity - add Sodium bicarbonate
Calcium hardness - add Calcium chloride
If you have an above ground pool and it is on uneven ground then one side will be deeper then the other and the water will be further away from the top edge on side.
We would not have a nice pool to Swim in
It would get wet and sink!
it would get dirty
If you build up a level area to place your pool you will have no problems. If you place the pool on the ground the way it is your water level will only be as high as the lowest side of your pool.
A good way to see if you have a leak in your pool is to # take a bucket and fill it with water from your pool. # mark it at the water level. # mark the pool at the water level. # wait a few days if there is no leak in the pool then the water level in the bucket should have reduced by the same amount as the water level in the pool, however if the water level in the pool has gone down more then the water level in the bucket you have a leak in the pool or in the pipes around the pool.
The water will level itself so you can live with it if you would like. Otherwise, emptying the pool and setting it up again sounds like what you have to do.
Yes but you would probably be wise to compact it before putting the pool on it.
Unless it hit you, nothing.
It would tip over but still float.
You would get sick and may die but ONLY IF you drank it out of the bottle, not in a pool.
It would fluctuate widely.
You will need to level the area under the pool, though. Most suggest using sand to do this.