0
clock generator is a supprting chips that generates three types singles just like
clock, reset,ready signal.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
8284 clock generator?
explain 8284A clock generator
Use of low frequency clock generator?
How to make Low frequency clock generator using ANAD gates?
Which IC is used as clock generator in 8086?
The 8086 Microprocessor operate to require frequency that is provided by clock generator to 8086 Microprocessor and also Synchronization various component of 8086.
What is the role of clock generator in microprocessor?
The clock signal in a microprocessor allows synchronization of several components of the microprocessor. The correctness of the computation of the microprocessor depends upon efficient and balanced distribution of the clock signal. The clock generator generates the clock signal.
What is 8284 clock generator?
that is the pakistan of india in africa
What is duty cycle in microprocessor?
It is the ratio of the on and off time or the clock signal, which is generated by the clock generator...
How clock signal are generated in 8085 and what is the frequency of the internal clock?
Early microprocessor neded clock input to be given externally, i.e. an extra clock generator chip is necessary. the clock generator chip had two pins between which a crstal or an RC circuit could be connected for the generation of basic frequency desired. however, microprocessor, that were designed after 1978(Intel 8085, M6809, etc.) had the clock generator circuit embedded in the microprocesor chip.
What is the difference between the pulse generator and clock generator?
clock is consider every signal time duration (on time and off time period) are must be constant.pluse is consider on time or off time period are same time period or it varies.
How is a mechanical clock better than a electric clock?
In the past mechanical clocks were used to check the frequency in generating stations. The mechanical clock was used as a standard as its time keeping was not affected by the frequency of the generated voltage. The two clocks were mounted side by side for easy viewing by the generator's operator. If the electrical clock was faster than the mechanical clock this would tell the operator that the frequency was high and had to be turned down by reducing the speed of the generator. Likewise if the electrical clock was slower that the mechanical clock then the operator would have to speed the generator up a bit. Now this is all taken care of by electronic monitors. The frequency is checked many time a second to make sure it is still in the correct rangethat consumers depend on for frequency driven equipment.
What are the steps to change a 6 volt system to a 12 volt system?
Change all the bulbs on the car, the radio, clock, battery, starter, and generator or alternator.
A clock radio is rated as 30 W of power output If the radio also draws 30 W at 120 V which will the current draw be?
A clock is not a generator so it does not have any power output. If anything the clock could consume 30 watts of power in its operation. The formula you are looking for is I = W/E, Amps = Watts/Volts.
Specify the crystal frequency required for an 8085 system to operate at 1.1mhz?
The crystal frquency in an 8085 system is twice the desired clock frequency, so a crystal of 2.2 MHz is required to operate at 1.1 MHz.Note: Clock frequency is not the same as instructions per second, because the instructions in an 8085 take a variable number of clock cycles, between 4 and 18, to execute.
