Measure the middle of the holes. I'd say 90 % of the time a lavatory faucet will be 4" but the are a selection of 8". You wouldn't really need to measure 4" or 8" are going to be your options and the is a pretty obvious difference between 4" and 8".
4 inch center the 4 3/4 spread is the distance outside to outside the sink will more then likely measure 5 inch spread in not more
form_title= Motion Sensor Faucet form_header= Install a motion sensor faucet in your home! Do you need to remove an old faucet? *= () Yes () No How many faucets do you want to install?*= {1, 2, 3, 4, 5, More than 5} What color do you want the faucet?*= _ [50]
As far as I know, all kitchen sinks have the faucet in the middle. There are usually 4 holes, 3 for the faucet and one for the hand sprayer. Some have a fifth hole for a soap dispenser.
form_title= Bath Faucets form_header= Create your dream bathroom with a new bathroom faucet! What type of faucet do you want installed?*= _ [100] How many bathrooms are in your home?*= () 1 () 2 () 3 () 4 What is your budget for the faucet?*= _ [50]
By increasing the spout diameter and boring out the faucet seats as the 1/4" opening allows only a certain amount of volume
There was air in the line. When you turn off the water with the faucet running make sure you turn it back on with the faucet open. That will release any air caught in the lines. That faucet shut with one on a lower floor on and restoring water does not work. Fast and easy. 1. turn on affected faucet 2. shut off water 3. turn water back on 4. faucet should be running smoothly now
You can get a cover plate that conceals the old plumbing while another single handle new faucet is installed in its place. Moen is the best. See the related link for a site for browsing the plates. You can pick them up at your local plumbing or hardware store.
A faucet aerator is usually attached to the end of a faucet.
The faucet is also called the Water Tap in English.
No, if the current faucet doesn't have a sprayer, there is no place on the faucet to attach the sprayer. It would attach on the underneath side of the faucet in the center.
Depends on the holes in the ledge of the sink. If you have a single hole, you have to buy a single lever faucet. If you have a two hole or three hole ledge, it depends on the space between them to determine if you need a 4" centre or 8" center faucet