Well, if your speaking very basically, a series circuit will have only 1 route to flow, and that's around the entire series circuit. Current leaves the source, and returns to the source, around a single path.
If in doubt with electronics theory, remember this analogy. Electricity is like water in a pipe Voltage= Water pressure (Not directional, doesnt flow in a linear sense)
Current= Rate of water flow (Wider pipes, more current! Resistor's are like kinks in a pipe, limiting flow. This is expressed in Ohm's Law as I=V/R. As R increases, current decreases)
A series circuit.
A simple circuit. Also, a serial circuit.
Because there is only a single path in series circuit and many paths in parallel circuit.
A path that is made for an electric current is called a circuit. The two main components in a circuit are the load and a source which are combined with conductors and as a whole form a circuit.
Ohm's law states that the current in a circuit is inversely proportional to the circuit resistance. There is a single path for current in a series circuit. The amount of current is determined by the total resistance of the circuit and the applied voltage.
A series circuit is one is which all current is restricted to one path. A good example of a device that is series-connected is a circuit breaker.
if the circuit is a series circuit (all loads wired in a single line , one after the other ) then the current will be the same in any part of the circuit . if there are several different paths for the current to take , then each path will carry a different percentage of the total current . when each of these different current values are added together , they will equal the total supplied current.
The circuits conductor serves as a pathway for current to flow.
A closed circuit.
A closed circuit.
its called a complete circuit
Any path that will allow charge to move. Usually it means a good conductor like copper or other metals.
Circuit
Fish
Parallel means 2 straight lines and series circuit means a circuit with only one pathway for current flow
when the blood follows one circuit pathway through the body , it is termed as single circuit plan
Its circuit. But this is hard to marry with lightning, which is the path of an electric current.
Yes the circuit needs to have no breaks or have the switch open to let the electrons pass through.
A single route for electrical current is called a branch circuit.