0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is a coil pack assembly?
A coil pack assembly is a coil that controls 4 or more cylinder using separate igntion wires for each. On a Taurus it will control the 6 cylinders.
Where are the spark plugs located on a 2005 Chevy cavalier?
AnswerThere is not a typical wire setup for this car. It is under the big plastic coil assembly bolted to the top of the valve cover. The plugs are under each of the four boots you will see that come up with this assembly, you will see an electrical connector that connects to the ignition module on top and this in turn plugs into the coil assembly.- Dale in Twin Falls, Idaho, USA
What is the coil on the top of the distributor cap on 1979 Chevy truck?
That is the ignition coil.
Does a Chevy s10 2.2 have a coil or distribulator cap?
It has a coil pack but no distributor.
Where is the coil pack located on a 1998 Chevy Malibu with 2.4 engine?
Where is the coil pack located on a 1998 Chevy Malibu with 2.4 engine
1997 Chevy Venture van coil firing order?
what is the coil firing order on a 1998 chevy venture van with a 3400 engine?
Where is the coil pack on a 2005 Chevy Trailblazer?
The 2005 Chevy Trailblazer has Coil-On-Plug ignition coils so there are 6 "coil packs". Each one is mounted on top of the spark plug.
The location of the ballast resister for the coil on a 89 Chevy Blazer?
None -inside the coil
Where is the ignition coil on a 1976 Chevy truck?
The coil is attached to the top of the distributor cap.
Where does the negative and positive wires go on a Chevy 350 coil?
look at the coil, it is marked - or +
How do you change a pick up coil on a 1985 Chevy?
if the coil is on the distributor cap,remove cover then disconnect wires from the coil and remove coil. if coil is on engine then loosen the bolt and remove from coil mount
How do you replace a 1970 Chevy ignition coil?
take the wires off the + and - side of the coil, pull the coil wire out of the coil, unbolt the coil from the manifold, to install just reverse directions.
