0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is a circuit with no load?
An open circuit or a short-circuit (if that circuit is complete).
Explain the output wave form a circuit which has a zener diode in reverse biased?
A zener diode has a relatively constant reverse voltage, at the designated zener voltage. If you had a circuit, say, with an AC source, a resistor, and a zener, the waveform across the zener would be the AC source, clipped at the reverse bias zener voltage, and clipped again at the forward bias voltage, typically about 0.7 V.
How is a series circuit and a parallel circuit like their circuit names?
A series circuit is actually in series, but a parallel circuit, is Parallel
What is closed path throuth which current can flow?
An electric circuit.
What will happen if you connect identical integrated circuits in series?
Connecting integrated circuits is not the same as the much simpler cases of resistors, capacitors, inductors, motors, light bulbs, etc. Integrated circuits have designated functions, and they operate in concert with the surrounding circuit design. As such, the idea of "connecting identical integrated circuits in series" has no meaning in the general case. You would need to state what kind of integrated circuit is involved.
What is control position?
this is a circuit in which the switch is located before the load in the circuit
What is the difference between a run and a circuit?
run in a electrical system means a wiring & conduit runs coming from Panel Board Circuit Breaker to its branch circuit loads in a circuit. while circuit is a designated number of branch breaker in a panel board where power load was individual connected.
What is disable in electronics circuit?
A: complex IC can have a pin designated as enable that will allow the IC to perform a decision to let its output contribute the the scheme of things
What is the meaning of current in a circuit is never lost?
Current flows in loops. It doesn't just "stop" at some designated location. So if you have 1.5 amps flowing into a location in a circuit, 1.5 amps will be leaving it as well. It will not magically disappear, or like voltage, just stop.
Is it within code to hard wire a fluorescant light fixture into a 20 amp branch circuit that is now designated for general use utility receptacles?
It is not good practice in new wiring, but done all the time as part of a retrofit. Use 12 AWG wiring and make sure the circuit is not overloaded.
What is the synonym of designated?
The synonym of designated is specific
Def designated units do what?
DEF designated units
Why is the circuit a circuit?
Because circuit is a circuit.
Do you have to be licensed to be a designated driver?
no, you decide if your going to be the designated driver or not
When was Designated Drinker created?
Designated Drinker was created in 2000.
When was Designated Targets created?
Designated Targets was created in 2005.
How many pages does Designated Targets have?
Designated Targets has 384 pages.
