0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
In order to recover liquid refrigeration you must connect one hose to the?
If the hose is hooked to the compressor discharge it can cause it to blow up. It should be hooked to the liquid line.
Where is orafice tube on Pontiac gran am?
What year? On a 2002, take the discharge hose from the condenser apart and you should find it in the hose end.
What is the hose called that runs from the compressor to the radiator on a 2000 Chevrolet S10 Blazer LT?
Depends, It could be either the discharge or suction hose.
Where is the valve to add freon on a 2006 ford focus?
The low side service port is on the suction side (larger hose) and the high side service port is on the discharge hose (smaller hose)......
Which is the low side port and which is the high side on a compressor?
Low side is the suction side and will have the larger hose attached to it and the high side is the discharge side and will have the smaller hose........
Where do you add freon in the 2005 Ford Focus?
On the suction side only if you are just using a do it yourself kit........ The low side service port is on the suction side (larger hose) and the high side service port is on the discharge hose (smaller hose)......
What is the easiest and quickest way to siphon water from a wading pool with a garden hose without use of a pump?
If you have a low spot that you could put the end of a hose, than you could hook a hose to the other end and feed it water to get the flow started. After getting the water running, hold the connected ends under the water in the pool and take them apart. Keep the end from the hose going to the low spot under the water. Have something handy to put on the end in the pool to hold it down to the bottom. If there is no are leaks in the hose and you keep the end under water, it should mostly drain the pool.The discharge end of the hose must be lower than the intake end. When the level of water in the pool falls to the same level as the discharge end, the siphon will stop flowing. To drain a pool completely, the discharge end must be lower than the lowest spot in the pool and the intake end must be place at that spot. To start the siphon you can immerse the hose completely in water to get all the air out, plug the discharge end of the hose with your thumb or a suitable cap as you drag it over the side of the pool, and uncap it when the discharge end is at a low point. This method of starting a siphon avoids sucking or inhaling on the hose end, with the attendant risk of aspirating contaminated water into one's lungs.
How long of a hose can be used on a sump pump?
A sump pump discharge line should run as far from the foundation walls as possible.
Where is the valve to check the freon level on a Lincoln LS 3.9?
Yes...... Using a set of a/c gauges you will connect the red hose to the high side and the blue hose to the low side.. High side will be the smaller hose and the low side will be the larger hose...... High side is discharge and low side is suction side.........
Where do you find the connection for the freon 4 the air conditioning?
It depends on the year, make and model but the low side will always be on the suction hose which is the larger one and the high side will always be on the discharge hose which is the smaller one...........
Where do you refill the ac for my 05 Lincoln LS?
The low side service port is located on the suction hose coming off the rear of the a/c compressor and the high side is located on the discharge hose coming from the condenser.......
How do you add freon to 1995 Volvo 940?
Using a set of gauges you will put the blue hose on the low side which is the suction side and the red hose on the high side which is the discharge side and using the remaining yellow hose you will attach the can of freon and add the correct amount plus add oil as well........
