They are shafts driven by the timing belt, and they have lobes which open the valves. They are located on the upper part of the head, just below the valve cover. You ought to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
how do you replace antenna on a 1997 hyundai accent
The 1997 Hyundai Accent was equipped with the 1.5L 4-cylinder engine. The all season weight for this application is SAE 10W30 of API SL or better. It service fill with filter is 3.5-quarts.
The horn on a 1997 Hyundai accent is located behind the front bumper. It is placed on the passenger side of the vehicle behind the right headlight.
The 1997 Hyundai Accent OBD 2 port is on lower edge of dash next to kick panel
The IAT sensor on a 1997 Hyundai Accent is found in the piping for the intake system. The sensor will be plugged and mounted near the air box for the air filter.
Well in my 1997 accent it is located on the firewall in the engine if your engine is carburetor then it will be a plastic container
its under the back seat
changeing ignition barral
a certified mechanic can do this for $350
above your rear foglight switchgear panel.. I am working on a 1997 Hyundai Accent at the moment. The connector for the OBDII is located on the left side of the dash. It is tough to see because it is facing down... recessed inside the cutout for the foglamps... at the top.
A 1997 SC1 uses a single overhead cam, 4 cylinder engine.
May not be your car, but proceedure same http://forums.travel.com/toyota-camry-forum/617282-1993-toyota-camry-4-cylinder-ignition-coil.html Hope it helps
your slave cylinder is leaking,need to replace.
.044 thousand's of an inch
1920s hyundai 12 cylinder
The water pump on a 1997 Hyundai Accent is replaced by first removing the timing belt and draining the coolant. The alternator needs to be properly marked and removed. Then unbolt the water pump. Clean off the old gasket and install a new gasket with the water pump.
there are two small bolts in the back side of the cylinder that need removed and unattatch the break line. i had to soak mine in liquid wrench (rust cutter/remover) before i could get it loose and its a tight fit getting to the bolts but fairly easy to do
This page will tell you how to do this......good luck. http://www.maintainyourcar.co.uk/1999_hyundai_accent_window_winde.htm
reverse lights on a Hyundai get there supply from a switch screwwed into the top of the transmission just left of the air filter box if your looking down at it
Sorry, but this is not a job for a DIY-er. Leave this to a technician who is certified in AC repair.
if it's anything like the location on a 1999 Accent, then it's at the front of the engine block, under the passenger side headlight. it is can be viewed from the under the car.