A lanyard is another name for a rope or line. In fall protection it is a fall stopping or fall arrest component of a fall protection system.
A fall protection lanyard is designed with a section what will stretch out when the weight of a person lands on it, thus reducing the shock to the person of being stopped while falling. Once used to stop a fall, it can never be reused.
The lanyard connects your body harness to a designated anchor point that should be rated to hold at least three times the maximum amount of weight that might fall on it.
A lanyard is sometimes called your life line because it can literally save your life..
For fall protection a full body harness & shock reducing lanyard, with associated equipment and anchorage is required.If you are doing fall prevention, a belt and short lanyard (six feet or 2 meters or less) with appropriate anchor point may be sufficient.
In general, you measure from the feet if the worker is standing. However, if using a fall arrest system, such as a body harness and lanyard, and the anchor point is below the spot of the body where the lanyard attaches to the work, you should ADD that distance to your fall calculation. Example- you have a 6 ft lanyard, but are tied off to an anchor at your feet. Lanyard attaches to D ring between shoulders- total fall will be at least 10 ft- 6 ft of lanyard, plus 4 feet of slack (feet to shoulder blades).
A harness in the context of fall protection is a webbing of belts that can be tightened around legs, chest, arms, and waist and groin areas and is strong enough to support your weight at the end of a 6 foot fall without breaking or stretching significantly.It has a D-Ring on the back, also called a dorsal D-ring, that a lanyard hooks to.Together with the lanyard attached to the D-ring it forms a system that catches the wearer if he or she falls, and holds the wearer until rescue can arrive. A safety belt and lanyard is not acceptable for this function, as someone hanging from a safety belt and lanyard can begin to feel pain and suffer injury within minutes, while a harness can be tolerated for an hour or more.A person should be properly trained to use a safety harness. If there is no training you could still die while using it.
Assuming you are referring to an outboard boat motor- if the operator should fall or be thrown out of the boat, that lanyard pulls out of the safety switch and stops the motor.
What are the fall protection systems
An anchor point should be able to support a 5000 lb load, or twice the max anticipated load in a fall. For the average worker wearing a harness and shock absorbing lanyard, that is around 950 lbs. Most unistrut framing members are not designed to support that load. Bad idea.
No, there is no lanyard hole on the phone body. Alternatively, you can purchase protective case and attach a lanyard to it.
lanyard string
Fall protection is a very important skill to know in the workplace. The following is a website that offers MSA fall protection training in such area: http://www.millerfallprotection.com/training
The OSHA General Industry Standard requires fall protection be provided if the potential fall is 6 feet or greater.
Should the person operating the PWC (personal water craft) fall overboard, the lanyard will be pulled out and switch off the engine. This prevents the PWC going round in circles and injuring or killing anyone in the water.
Workers must be provided with fall protection when climbing at 10 feet.