0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
345 fastners at 4.15 will cost?
345 x 4.15 = _______
Differences between temporary fastners and Moveable fastners?
Temporary fasteners are used to temporarily bind two objects together. On the other hand, moveable fasters involve joining objects together of which, can be adjusted.
Things needed to build a toy car?
tissue box brass fastners and wheels motor wood
How do you remove ac compressor bracket to get to freeze plug?
Look for how it is attached and remove the needed fastners or components. No majic unfortunately.
How do you identify sizes of fastners just by look at it?
Work experience. Eventually you will know what size the bolt is and what size wrench it requires.
What are the torque specs for a CR125R?
it all depends on the size of fastner go online and print out atorque spec sheet for metpic fastners
How do you torque the camshaft?
If you do not have a manual for this vehicle, DO NOT PROCEDE! You have invaded the heart of the engine, and if you do not have a manual, you run the risk of doing damage to the engine if you put it back together wrong. YOU MUST GET THE CAMSHAFT ALIGNED WITH THE CRANKSHAFT IF THE ENGINE IS TO RUN CORRECTLY! Anytime you are reassembling a large component, with multiple screws or bolts, finger tighten all fastners until all fastners have been run down finger tight. Then, working across the component, tighten one fastner snug, then go to the diagonal fastner, and tighten it snug. FOLLOW TORQUE SPECIFICATIONS! If you are working without a torgue wrench, try to tighten all fastners as uniformly as possible. Torgue specifications are critical on many automotive parts, and it is worth buying or renting a torque wrench to get them right. Work all fastners down in steps, avoid tightening one faster all the way while others are loose or only finger tight. This can cause warpage of parts, and may prevent all fastners from being tightened properly.
2005 Honda odyssey rear hatch panel removal procedures?
Remove cover off of inside pull handle. Remove screws underneath. Remove screws around latch. Remove access panels on hatch cover where you replace rear tail light bulbs. With hatch above you pull the panel towards you section by section carefully as fastners pop out. Eventually all fastners will loosen up allowing the panel to be removed. Be aware some panel fastners are in the middle of the panel as well so you may have to stick you hand inside the panel areas that have come loose to apply some pressure to those areas.
What products does Southco sell?
Southco was originally established in 1899 as a specialty pipe manufacturing company. In 1945 they began making specialty latches and fastners, which is what they continue to make today.
How do you remove the liner from a World War 2 German M1940 helmet?
there are THREE fastners that hold the liner in place. they are located about mid-way up on the sides of the helmet. they are REMOVED from the INSIDE of the helmet
What is the procedure for removing the cowl on a ford 2006 mustang?
# Remove the windshield wiper arms # Remove the retaining fastners securing the cowl cover # Remove the right side cowl cover then the left side
How do you remove the factory luggage rack cross bars on a 2002 Town and Country?
There is no quick release on these. Remove the front brackets and slide the cross bars off forward then reinstall the brackets ... be certain the toeque the fastners down.
