you should go to kdmstuff.com and get it their it may be expensive but its worth it its directly from Korea and good for racing!
Under the dash, either on the pedal arm or the clutch rod.
clutch pedal doe yoo
You can push start a car with a standard transmission. Place the car in neutral. Push the car to a brisk speed. Mash down the clutch pedal and place the gear selector in 2nd gear. Pop the clutch, and it should start.
your tps or throttle position sensor
Remove the clutch lever off the top of the transmission and reinstall upside down then rotate counterclockwise as you pull the transmission out. To install do the process backward.
I have ran into aftermarket wheel bearings that the speed sensors do not read properly.I have ran into aftermarket wheel bearings that the speed sensors do not read properly.
If the clutch slips when not engaged. (Plates worn)If the clutch rattles when disengaged. (Bearing, basket issue)Acrid burning smell at speed when accelerating (Indicates the clutch is slipping at speed).
it was a 78 step side Chevy with a load of aftermarket performance parts,origanly it was a standard but in the movie they made it a factory three speed.
Used properly, yes. My daily driver is a 98 Chevy S-10 with a 2.2L standard 5 speed transmission and it has 187,000 miles on it and counting with the original clutch.
GREASE
The engine computer controls top speed. You will need an aftermarket programmer that is capable of changing that.The engine computer controls top speed. You will need an aftermarket programmer that is capable of changing that.
in 1997 they did not have speed governors. i have a 97 rs with aftermarket turbo and i can go as fast as i want! in 1997 they did not have speed governors. i have a 97 rs with aftermarket turbo and i can go as fast as i want!